Productos

The J-hook kit holds down the 20lb LP gas bottles on the front of the pop up. 20LB tanks are the most common size on pop up campers. Comes with 2 J...

These bulbs will replace most of the interior lamps in units from the 1970's to the 2000's. This bulb pushes in a round socket, and twist to lock i...

Light up the campsite with this LED porch light. With on/off switch. 12 volt. 9 diode LED bulb included. Video available Featured in this video ...

Crank cover for left hand chain drive lift systems. Found on 12 foot box models built between 2000 and 2002. Series 3500 Measures 13-1/4 inches wid...

A great addition to your pop ups accessories! These ultra-durable tumblers are made with kitchen grade 18/8 stainless steel with double walls vacuu...

Found at the four inside corners of the roof. The lift arms attach to these lift pockets with two 1/4” nuts. Pro Tip : Install the two 1/4” lock n...

Found at the four inside corners of the roof. This covers installs over the lift pocket. Some versions have Velcro the affix valance's around them....

Used to trim table and countertop sides. Sold in 12 foot length. Long enough to trim the largest table with one run. Choosing the correct size. Yo...

This latch is found on units where the access door lock sits to the side of the door, mounted in a body panel. Always found on access doors that sw...

Series 4100. 1/2 inch flared male fitting to 3/8 male. Measures 36 inches in length. Part number 4737-8871

Attaches to the high pressure regulator to the copper line that runs to the exterior stove. 1/4 male MNPT fitting to 3/8 male flare. Measures 30 in...

This track hangs the curtains and canvas.  The top channel accepts the type C tab type curtain hangers, and the bottom the canvas arrowhead seal. M...

Metal exterior drain nut. This jam nut is found on the outside sink drains on many Coleman and Fleetwood pop ups. Direct replacement for the plasti...

Installs on the whiffle tree and holds the 3000 series thrust bearing. Most commonly used on units with chain driven lift systems. Dimensions are 2...

Bracket for the pivot style bed support poles. This bracket installs under the bed frame, and pins the bed support pole that pivots down. Measures ...

Hard plastic slide rails for Coleman and Fleetwood pop ups. These slides work with the bed extensions that do not have rollers. These slide rails a...

Found inside the slide track rails for pre-1997 bed extensions that use bed rails with roller wheels. This track acts as a guide for the bed rails....

This lens works with this style porch lamp. Two mounting tabs on the bottom and one on the top. Measures 5-3/8 inches in length, 2-3/8 inches tall...

Used to raise and lower the roof on Coleman's and Fleetwood's equipped with power lift systems. This remote plugs into the current limiter which is...

Found on units built before 1997 that use roller style bed rails. This pin in installed in the top deck rail, and acts as a stop for the wheels and...

Used in crank assemblies, this washer has a slightly beveled edge for the shaft bushing. It's important to note the direction of this washer when r...

Measures 3 inches wide by 3 inches tall. Part number 4799C8642

Located just past the whiffle tree. This separator bracket is used to mount the 4 lift system pully's and guide the cables out from the whiffle tre...

The ratchet pawl is part of the mechanical brake for most lift systems. This cam engaging the ratchet wheel sprocket is what gives the Coleman and ...