Productos

The drive hub extension threads onto the drive shaft. This crank component is what you see sticking out of the camper, and what you put the crank h...

The drive hub extension threads onto the drive shaft. This crank component is what you see sticking out of the camper, and what you put the crank h...

The drive hub extension threads onto the drive shaft. This crank component is what you see sticking out of the camper, and what you put the crank h...

The drive hub extension threads onto the drive shaft. This crank component is what you see sticking out of the camper, and what you put the crank h...

This spring is found inside the drive hub extension tube. The original springs were a simpler design, typically a coil spring. This wave spring dir...

Used in every drive hub extension tube. Commonly two are installed. These are a very thin thrust washer.  Measures 15-16th inches wide. 1/2 inch in...

The drive hub pin is most commonly found installed at the end of drive hub extension. This is the pin that the crank handle grabs onto in order to ...

Used in the drive hub extension tubes on Coleman and Fleetwood crank assemblies. This spacer sits between the spring and flat washer, acting as a t...

The drive shaft bushing is found installed into the crank mounting plate. This bushing holds the rear of the drive shaft. Inserts into a 1 inch mou...

Double lamp ceiling light with on/off switch. Popular in later models such as the Highlander and Evolution series. Replacement 904 bulbs are availa...

Popular on 1990's and early 2000's models. 12 volt interior ceiling lamp. Squared design with on/off switch and power port for auxiliary equipment ...

Base plate mounting kit to add a second LP tank. Installs on top of the pop up A frame. Measures 37-1/4 inches across the top, 28-1/2 inches across...

An easy upgrade kit for adding two propane tanks. This kit mounts to the trailer tongue, and holds two 20 pound LP tanks. Comes with base, threaded...

Allows the hook up of two low pressure quick connect appliances. Comes with protective weather caps. Part number 06-0944

Commonly found on the largest units with dual sinks. Thin walled ABS 1-1/2 inch dual tailpiece. Measures 10 inches wide by 8-1/4 inches tall. Part ...

Holds the tent support poles with duck bill caps to the ceiling. Referred to the steel loop in the parts books, this can also be found for table br...

The dust cap is found at the center of the wheel hub. It keeps dirt and weather out of the wheel or hub, protecting the bearings. 2" Diameter. Twin...

Perfect for pop ups! its small size makes it easy to keep this duo close at hand. Whisk broom snaps into dust pan when not in use. Hanger-hole fo...

Multi patch kit for most E1, E2, E3 and E4 Fleetwood units. Adaptable to other camper manufacture that have grey canvas sections with black vinyl b...

The Eaz-Lift Light Weight RV Tire Leveler allows easy leveling without using blocks or ramps. It raises a trailer axle up to 8-inches when fully ex...

 Eaz-Lift's 24-Inch Scissor Jacks fit pop-ups, trailers and other large vehicles. They allow for either bolt-on or weld-on installation. The scisso...

The Echo mobile trailer brake controller is truly a brake control for the modern age. It plugs into your vehicle and wirelessly connects to your sm...

Allows you to safely carry up to (12) eggs. It is ideal for RVing, camping, picnics, tailgating, road trips and more. This compact, virtually unbre...

Used to trim cabinet sections together. This style and color is commonly found in units built through the 1990's Color = Elm Please select your len...