Productos

Mounting nut for faucets with 3/4 inch stems. This nut is what secures the faucet to the sink countertop. It installs onto the hot or cold water li...

Series 2900 1/4 inch threads. Part number 4744-8261

White plastic fender skirt. Installation hardware is included. Directly compatible to the following unit. 2006 Niagara Measures 25-3/4 inches lon...

Right angle filler bracket with rivets. Painted brown. Series 2300 Measures 3-1/2 inches in length with a 1 inch width on each side. Part number 47...

Used to trim cabinets and hutches. Metal panels with a simulated birch wood look. Found in early 1980's pop ups. The largest panel measures 15 inch...

Used in upper crank assemblies, and the lower left hand chain drive system found on certain 12 foot box units. The crank assembly gears and mechani...

This 5/8 nut threads onto the end of fine thread drive shafts. This is the final nut found on the end of drive shafts for crank assemblies. Early v...

Finger pull handle for the grey storage box system found on later model Fleetwood's, and Somerset's. Install at the top lid. Most commonly installe...

Recessed wall mounted fire extinguisher bracket. Features a plastic strap to lock and hold the fire extinguisher. The mount will hold a 2 lb 5BC f...

Used in air conditioner roof brace installations, this 1/4 inch flange nut has a locking feature at the bottom of the nut. Sold individually. The i...

Installed at the lift pillars, this trim kit keeps weather and debris out of the lift arms and act as guides for the lift arms. Finding these trims...

This latch is found on units where the access door lock sits to the side of the door, mounted in a body panel. Always found on access doors that sw...

This particular washer is commonly found in air conditioner brace installation kits. 1/4 inch inside. Measures 5/8 of an inch outside diameter.  So...

Installs at the ceiling under the duck bill support bracket. This pad creates friction for the duck bill, helping keep the tent support pole in pla...

Replaces cracked and stained trim inserts. Easy-to-install. Remove your old vinyl insert from the channel and replace it with this new vinyl insert...

Replaces cracked and stained trim inserts. Easy-to-install. Remove your old vinyl insert from the channel and replace it with this new vinyl insert...

Sticky ingredients release quickly from the flexible bottoms. Storage ring keeps the cups together. Set includes 1/4 tsp (1. 25 ml), 1/2 tsp (2....

Replaces cracked and stained trim inserts. Easy-to-install. Remove your old vinyl insert from the channel and replace it with this new vinyl insert...

Flip up prop lid with hinge. Directly matched to the following units. 1991 Santa Fe Series 3189 2003 Utah Series 3781 Measures 6 inches tall by 3...

This cover is designed to fit a flip over mattress. Directly matched to 1999 Redwood models built prior to 12-2-1998, up to VIN number ending in 64...

This cover is designed to fit a flip over mattress. Directly matched to 1999 Redwood models built after to 12-3-1998 with VIN numbers after 64201. ...

Backrest for the dinette system. This hinged bracket flips up to provide dinette cushion support. Measures 21-1/2 inches wide by 8 inches tall. Par...

The Flow-Longer Propane Kits are designed to connect small portable appliances, normally fueled by disposable LP-Gas cylinders, to the existing LP-...

Fresh water when you want it and when you need it. Lippert Components Flow Max water pump delivers a steady flow of water to your RV. Compared to o...