Productos

Replacement jack handle for the swing down jacks. Works with the following style jack. Part number 4716-1951

Plunger kit for the swing down jack. This is the pull pin that sets it in stored or down position. Measures 4-1/2" tall. 3/8" diameter. Comes with ...

Replacement jack wheel for the swing down jack. Wheel measures 6 inches in diameter. Works with the following style jacks. Part number 4716-1971

These swing down corner jacks come equipped on most small box sized Coleman and Fleetwood pop ups. Video available Rated to 1000 Lb. Adjust from ...

Side mounted swing down jack. Mounted to the side of the camper A frame with a large  clip. Swings up and out of the way for travel. Swings down fo...

Large C clip for swing down tongue jacks. These are the jacks that are mounted to the side of the pop ups A frame. Measures 2-5/8 inches in diamete...

Highwall series swing style access door. Directly compatible to the following units 2004 Sequoia Series 3831 2004 Redwood Series 3832 Comes with ...

Wheelchair accessible swing style access door. Found on just a few hundred units made in the early 1990's. Directly compatible to the following uni...

Found on swing style doors. This hinge allows the opening and closing of the door. Measures 24-3/4 inches long by 2-1/2 inches wide. Part number 47...

Lower support side bracket for swing style doors. Series 3000. Measures 2-5/8 inches wide by 1 inch by 1 inch. Part number 4749B1278-USED

Exterior panel for swing style doors. This is an extra large door skin. Please confirm your measurements before ordering. This will be found only o...

Exterior panel for swing style doors. Directly matched to the following units Somerset Evolution Models A few of these skins have some minor cosm...

Mounting plate for the 12 volt switches found in your pop up camper. This plate fits the following interior switches. Kill switch Water pump switc...

Water line connection with a 90 degree elbow. Internal threads accept 1/2 inch male pipe thread connection. A 3/8 inch and 1/2 inch barbed connecti...

Used as the end cap for table legs, as well as the end caps for the tent support poles. This cap inserts into the pole or leg end, providing a fini...

Lower and upper support bracket for exterior tables and stoves. This bracket can be found on an exterior body panel, top deck, frame rail or inside...

Lower support bracket for the exterior tables and stoves. This bracket can be found on an exterior body panel, frame rail or inside a swing style d...

Left hand and right hand table top braces. These braces install at the dinette system to covert it into a bed. Light beige in color. Two braces are...

Metal table leg for free standing dinette tables. This size of table leg is one of the most common in pop up campers. The tubular design makes it l...

Mounts to the underside of the table, the table legs pivot on the nylon roller. This bracket will work with other designs that had different mounti...

Complete kit for the installation of your campers table legs. Comes with 8 pre cut self adhesive pads and 40 wood screws. Video available Pads in...

Used for table leg storage. This kit is attached to the bottom of the dinette tables and secures the legs when closed. Measures 13 inches long by 1...

Coleman and Fleetwood pop up tables have two of these legs. They are both the same, and work in both the left hand or right hand application. If yo...

Wooden stile for the dinette table rest. Natural wood color. Measures 21 inches in length. Part number 4752B4731