Productos

Couples the power lift motor to the whiffle tree. Measures 6 inches in length. Part number 4768-0851

This component is what the remote plugs into. Only two different style current limiters were used and the plugs easily differentiate them. Power be...

Mounted to the rear of the trailer, this bracket mounts the power lift motor. Applicable to both round drive and square drive lift motors. Measures...

The Hughes Autoformers 30A Bluetooth Portable Surge Protector is the world's first and only 'Smart' RV surge protector. The Power Watchdog Smart Su...

Designed for larger pop ups that require a bit more more power, this converter has the distribution you need with some extra room to grow. Video a...

Power lift system for Goshen and similar. These lift systems use one main lift cable to the winch or motor. Not applicable for Coleman and Fleetwoo...

Found on units built before 1997 that use roller style bed rails. This pin in installed in the top deck rail, and acts as a stop for the wheels and...

We've cut them to the correct size for you! These bolt end cables are designed for Coleman and Fleetwood pop ups built after 1999.  How to install ...

Commonly referred to as the crank assemblies clutch pad. This plate rides between the ratchet wheel sprocket and chain drive sprocket in chain driv...

Used in crank assemblies, this washer has a slightly beveled edge for the shaft bushing. It's important to note the direction of this washer when r...

Light grey privacy panel with white mesh top. Button snaps attach the curtain to the ceiling. Designed for the bathroom area. Directly matched to t...

Toilet, shower, and change room all in one!  Accommodates all port a potties and has mounting locations for a portable shower. When you are done, t...

Never run out of LP again with this gas gauge and leak detector. Installs easily on the LP bottle and gives an accurate reading of how much propane...

Measures 6 inches wide by 3-1/2 inches tall. Part number 4716-8701

Measures 4 inches wide by 2-1/2 inches tall. Part number GD0002

Measures 3 inches wide by 3 inches tall. Part number 4799C8642

Lock two propane tanks to your camper to help prevent theft. The lock works with conventional setups and fits ½-inch and 3/8-inch threaded posts. A...

This pins holds the lift system pulleys in the following locations on the camper. Adjustable pulley brackets Lift arm butterfly pulley bracket Me...

The application for this pulley retainer is at the cable routing just past the whiffle tree. Typically 2 pulleys are stacked one on top of each oth...

Pin for lift system pulleys. Measures 1 inches in length. Part number 4731B252

Used to hold the lift pulleys in brackets inside the lift arms. This shorter pin is most commonly found at the top stage pulley. Measures 3/4 of an...

Used to hold the lift pulleys in the stage brackets on lift arms. This longer pin is most commonly found at the lower stages. The next upper stage ...

This plate is found in the pulley routing block just past the whiffle tree.  Measures 4-1/4 inches long by 1-3/8 inches tall. Part number 4720F154