Coming Back Soon

Storage box door hinge for built boxes that have plastic sides and wood interiors. New style metal hinge. This is an upgrade to the original plasti...

Used to trim table and countertop sides. Sold in 12 foot length. Long enough to trim the largest table with one run. Choosing the correct size. Yo...

Used in crank assemblies, this washer has a slightly beveled edge for the shaft bushing. It's important to note the direction of this washer when r...

Everything you need to install a USB self powered water faucet directly to your fresh water tank. This solution is perfect for smaller units that o...

Easy DIY bendable shower track kit for your camper. This kit features an easy to bend track that can be hung or mounted directly to the ceiling. Th...

The bed bow provides bunk end canvas support. This is the large U shaped pole that folds up from the beds and holds the ends. This Click Lock bed b...

Attaches to the high pressure regulator to the copper line that runs to the exterior stove. 1/4 male MNPT fitting to 3/8 male flare. Measures 30 in...

The bed bow provides bunk end canvas support. This is the large U shaped pole that folds up from the beds and holds the canvas ends. This Click Loc...

The bed bow provides bunk end canvas support. This is the large U shaped support pole that folds up from the beds and supports the canvas ends. To ...

Found on later model units, this roof corner cap kit will fit both the front or rear of the pop up campers roof. Comes with two corner caps, and ca...

The lift arm provides lift to the pop up. They are found in each corner of the camper. CSR / Curb Side Rear RSF / Road Side Front Videos availab...

The shepherd's hook attaches to the bed bow and provides the center canvas support over the beds. King sized, this tent pole style is a direct repl...

Comes with strap and hardware. Strap measures 8-3/4 inches in length. Part number 4716-9691

This LP hose runs from the propane tank to the low pressure regulator. Acme nut to 1/4 inch inverted MPT. Hose measures 15 inches in length. The in...

The glide out bow provides end canvas support at the dinette. This is the large U shaped pole that folds up from the dinette and holds the canvas e...

White nylon strap with hook and loop Velcro to secure the shower cabinet top when lifted up. Comes with installation hardware. Measures 30 inches i...

Series 4100. 1/2 inch flared male fitting to 3/8 male. Measures 36 inches in length. Part number 4737-8871

The duck bill attaches to the ceiling end of the shepherds hook, or tent support pole. Sometimes the tip out or glide out pole uses this cap at the...

Fits 13" sized tires.  Strong black vinyl with corded edge and elastic closure for a snug fit. Protects tires or spares from sun and foul weather f...

Found on many Coleman and Fleetwood pop ups with galley lift system sinks. Installs to the bottom of the sink and connects to the drain hose. Measu...

The most common of all Coleman and Fleetwood pop up crank handles. This handle works on almost all units with original equipment drive shafts and d...

Roof mounted tent pole bracket. The double push pins commonly found on the end of shepherd hook poles accept into this brace. Two are found in the ...

Fits almost every air conditioner installed on Coleman and Fleetwood pop up campers. Direct fit: Coleman Mach 1, 2, and 3. The most common Coleman ...