Crank Assemblies

Let us do the cutting for you! These bolt end cables are designed for Coleman and Fleetwod pop ups built after 1999.  How to install cables With ...

This chain drive crank system is commonly located behind a rear body panel. This is the compression system and ratchet upper crank. When you turn t...

This chain drive crank system is commonly located behind a rear body panel. This is the compression system and ratchet upper crank. When you turn t...

This is the crank assembly found in 12 foot box models from 1999 till 2002. It is installed at the left hand side of the bumper. A chain drives the...

This popular crank system for Coleman and Fleetwood pop ups is for units with lower direct drive lifts. This crank is found in the rear bumper, dir...

Popular on 1990's Destiny Series Trailers. This crank system for Coleman and Fleetwood pop ups is found on units with lower direct drive lift syste...

Front mounting plate for both the 3000 and 6311 direct drive crank assemblies.  Measures 7-3/4 inches wide at the base by 3 inches in height.  1-1/...

One of the earliest designs of Coleman Crank Handles. This type of crank handle was used from the start of prouction to the 1980's for most units. ...

The most common of all Coleman and Fleetwood pop up crank handles. This handle works on almost all units with original equipment drive shafts and d...

The drive hub extension threads onto the drive shaft. This is the crank component that you see sticking out of the camper and what you put the cran...

Used in upper crank assemblies, and the lower left hand chain drive system found on certain 12 foot box units. The crank assembly gears and mechani...

Used in upper crank assemblies. The crank assembly gears and mechanism ride on this drive shaft. The drive hub extension tube threads onto the seco...

Used on lower drive drive crank systems, that are located directly at the center of the bumper. This drive shaft works in the 6311 and 3000 direct ...

This 5/8 nut threads onto the end of coarse thread drive shafts. This is the final nut found on the end of drive shafts for crank assemblies. Early...

Installs on the whiffle tree and holds the 3000 series thrust bearing. Most commonly used on units with chain driven lift systems. Dimensions are 2...

Whiffle tree pan found on many Destiny series pop ups. This cover becomes the complete whiffle tree guide, and is bolted to the cross members. Meas...

Crank cover for left hand chain drive lift systems. Found on 12 foot box models built between 2000 and 2002. Series 3500 Measures 13-1/4 inches wid...

Used in crank assemblies, this washer has a slightly beveled edge for the shaft bushing. It's important to note the direction of this washer when r...

The ratchet paw is part of the mechanical brake for most lift systems. This cam engaging the ratchet wheel sprocket is what gives the Coleman and F...

The crank shaft bushing is found a the rear of ratchet and clutch crank assemblies. it supports the rear of the drive shaft. Inserts into a 1 inch ...

Used on many chain driven crank assemblies. This gear drives the 12 tooth gear, and is found in many upper cranks and left hand cranks. Some versio...

Used on coleman and Fleetwood pop up with an upper or left hand crank assemblies. The chain runs from the crank assembly to this gear. This gear th...

The lift arm provides lift to the pop up. They are found in each corner of the camper. CSF / Curb Side Front RSR / Road Side Rear Videos availab...

Found on 3 stage highwall lift arms, this is the bottom section. Highwall units typically have body panels that measure 28 inches in height. The to...