Products

Black rocker switch 2 position with mounting plate. 12 Volt rocker switch mounted on a 1-5/8 inch by 2-5/8 inch plate. Ideal for remote switching o...

The primary application is to pin the chain drive gear to the drive shaft in upper, and LH crank assemblies. Measures 1-1/2 inches long. Part numbe...

Used in lift systems to pin gears and couplers together. Measures 1 inch in length. Part number 4744-1351

Camco's Roll-Up Dish Drying Rack rests easily on your sink and provides extra drying space for dishes, pots and pans. It is heat-resistant up to 45...

Used in pre-1997 bed rails. Spaces the roller wheels out further if required. Some units require up to 3 roller spaces between the bed frame and th...

Roller tower for the glide out systems. Commonly found on larger Grand Tour and Highlander units. This tower is one of three in this size that faci...

Roller tower for the glide out systems. Commonly found on larger Grand Tour and Highlander units.  Frame measures 7-1/2 inches tall, 3-1/2 inches w...

Roller tower for the glide out systems. Commonly found on larger Grand Tour and Highlander units. This 8 inch wide tower is one of four in this siz...

Roller tower for the glide out systems. Commonly found on larger Grand Tour and Highlander units. This 8 inch wide tower is one of four in this siz...

This latch is found on the sidewalls holding the roof closed, and storage box bins on pop up campers. Pulling down on the latch clamps the roof and...

This latch is found on the sidewalls holding the roof closed, and storage box bins on pop up campers. Pulling down on the latch clamps the roof and...

Latch brackets for the roof and storage compartment latches. Sold in a 2 pack with 4 screws. Measures 1-1/4 inches wide. Please select your color f...

Roof angle for the installation of vanity mate and camper caddie systems. designed primarily for filon tops   Measures 2-1/4 inches tall with a 2 i...

Designed for Coleman and Fleetwood campers with metal or filon tops. This brace could be required for an air conditioner installation or a sagging ...

Designed for Coleman and  Fleetwood campers with metal or filon tops. This brace could be required for an air conditioner installation or a sagging...

Designed for Coleman and  Fleetwood campers with metal or filon tops. This brace could be required for an air conditioner installation or a sagging...

Designed for Coleman and  Fleetwood campers with metal or filon tops. This brace could be required for an air conditioner installation or a sagging...

Designed for Coleman and  Fleetwood campers with metal tops. This brace could be required for an air conditioner installation or a sagging roof. Th...

These brackets fit the the left hand and right hand ends of the 4800-4811 roof brace. They secure to the roof curtain and canvas tracks and hold th...

Roof brace cover. Cover measures 79-1/4 inches long by 5 inches wide. Removed from a 1986 Plantation series Savannah.    Video available Part num...

4 caps to replace all the corners on your Coleman or Fleetwood roof. These are the original completely smooth caps. Two different versions were ava...

Found on later model units, this roof corner cap kit will fit both the front or rear of the pop up campers roof. Comes with two corner caps, and ca...

4 caps to replace all the corners on your Somerset or Fleetwood roof.  These are the later styled versions with grooves to accept the metal extrusi...

This roof cap end panel has interior brackets that are open on the bottom.  Measures 86-1/2 inches wide by 10-1/4 inches tall. This item is Shipped...