Products

Square drive coupler to attach the lift motor to the whiffle tree on newer units. This coupler works directly with our square drive lift motor foun...

Square drive design. Only two lift motors were used and they are easily identified by the shape of the drive coupling. This motor incorporates a "s...

The whiffle tree is the threaded rod mounted in the bottom of the pop up. A draw bar runs up and down the rod and pulls or releases the cables. Thi...

Accepts a 1-3/8" water fill hose. Comes complete with a vent. Direct replacement for Coleman and Fleetwood pop up fresh water fill hatches for olde...

Black squared plug cap. Plastic. Fits 1 inch by 1 inch openings. Part number 4506-9411

Commonly found on units from 1968 to the late 1980's. Video available Installation screws are available   Cutout dimensions are 3 inches round....

Installed at the lift pillars, this trim kit keeps weather and debris out of the lift arms and act as guides for the lift arms. Finding these trims...

The most common of all Coleman and Fleetwood stabilizer jacks. 17 inch reach with a single arm that lowers when cranked. Designed to mount on the f...

A slightly larger Coleman and Fleetwood stabilizer jack. This jack is designed for units that may have over-sized tires or an axle flip that has gi...

Looking for an easier tool to raise and lower your screw down stabilizer jacks? This long reach handle measures 14 inches to make this task much ea...

Extra Large stabilizer jack. These jacks were only used on a few units, and they were always the largest units. Popular on early model Highlander s...

Jack mounting bracket for Highlander series pop ups. Series 3600C Measures 8-1/8 inches wide by 5-1/8 inches long by 2-1/2 inches tall. Part number...

Jack support bracket for Destiny series pop ups. Measures 9-3/4 inches wide by 3 inches tall. Part number 4746-8761

Stackers leveling blocks. Ten to a pack stored neatly and compactly in their own carry case. This multi-use product can be used as a leveler, jack,...

Found in the upper lift arm stages. This clip helps secure the next stage cable to the pulley pin. It can also be used to clamp the stage and main ...

This convenient starter boxed kit is the easy way to outfit your pop up camper with the basic accessories you need to start the season out right. I...

Metal. Measures 5-1/2 inches long. Part number 4750-3361

Bulkhead for the right hand side of the stepper door, facing. Found on certain Destiny series pop ups. Measures 27-1/2 inches tall by 6 inches wide...

Bulkhead for the left hand side of the stepper door, facing. CSR / Curb side rear. Standing outside the camper facing The door this bulkhead would ...

Bulkhead for the right hand side of the stepper door facing. CSF / Curb side front. Standing outside the camper facing the door this bulkhead would...

This fastener is found installed in stepper doors and stepper door bulkheads. The stepper door swing arm rivets accept into this rivet nut. Four ar...

Curved stepper door skin. Commonly found on units produced through the 1970's and 1980's. Colonial white in color. Measures 23 inches wide by 22 in...

The door skin is the exterior metal panel on stepper doors. Recently manufactured to fit stepper doors with an under door storage compartment. Your...

This pop rivet that attaches the swing arm to the stepper door, and to the stepper door bulkhead. This product does not fix a swing arm that is bro...