Products

Angle brackets that position the battery box to the front frame of the camper. Comes with 2 brackets and installation rivets. Brackets measure 1-1/...

This strap wraps around the battery box and lid which secures the battery box to the camper frame. Measures 54 inches in length. Part number 1490141

Unique to the Contour Battery Master Switch is the patented contour lock system which allows the switches to be used as stand alone units or locked...

Designed to repair broken 12 volt battery harnesses. Comes with both sides of the battery connections, along with crimp able connectors for easy re...

Designed for pop ups with one to three 12 volt appliances. Connects the 12 volt battery to the factory harness on Coleman and Fleetwood pop up camp...

Designed for larger pop ups with 4 or more 12 volt appliances. Connects the 12 volt battery to the factory harness on Coleman and Fleetwood pop up ...

No more disposable cylinders. High-pressure hose with adapter for use with high pressure gas grills.  Male P.O.L. x 1"-20 Throwaway Cylinder Thread...

Low pressure hose kit for Coleman sidekick low pressure grills. Comes with everything you need to connect your Sidekick grill to the low pressure q...

The perfect accessory for a day at the beach or the pool. The towel features a decorative RV pattern design and is made of 100% cotton. It measure...

This housing covers the thrust bearing. It is used on almost every Coleman and Fleetwood pop up camper. Bolt it directly to the crossmember or fram...

Square spacer bearing retainer housing. Used in 6311 lower direct drive crank assemblies. Measures 2 inches by 2 inches squared. 9-16th of an inch ...

Used at the end of some direct drive crank assemblies.  Measures 2-1/2 inches by 2-1/2 inches. 1 inch inside diameter hole. Part number 4756-8321

Used to reinforce or space the thrust bearing. Measures 4 inches wide and 2-3/4 inches tall. 1-1/2 inch diameter hole. Color : Black Part number 47...

Lower pivot bracket for the bed bow. This bracket installs at the left and right of the bed extension. It installs with two pop rivets and one wood...

A common fail point for Coleman and Fleetwood pop up camper bed bows are right in the middle. This kit is designed to fix bed bows that have suffer...

Commonly found at the bed bow mounting bracket.  This washer acts as a wear spacer between the brackets and the bow. Measures 1-1/2 inches in width...

Bed frame sections for the pull out beds. This twin kit replaces the sides of the bed frame. Directly compatible to the following unit and location...

Bed frame sections for the pull out beds. This twin kit replaces the sides of the bed frame. Directly compatible to the following unit and location...

This is the channel that bolts to the bottom of the beds, and the bed support pole slides in. This complete kit is ready to accept your bed support...

Found under the bed extension, these clips hold the bed leg poles up under the beds when stored.  Measures 1-11/16th inches across. 7/8 of an inch ...

Found under the bed extensions, these clips hold the bed leg poles up under the beds when stored.  Measures 5/8 of an inch wide by 3 inches long.  ...

Make pulling out the beds a breeze with this kit! These pull handles can install on all pop up camper bed extensions. They make controlling the bed...

This cap is found at the end of the bed rails on Fleetwood pop ups built after 1998. It is attached with a single bolt and nut to the end of the be...