Products
Filters
Galley Hinge Used
This hinge pivots the fold over galley sink system in pop ups. It is found screwed to the front top of the galley countertop, and lowers the galley...
View full detailsGalley Kitchen Sink Faucet
This faucet is a common replacement for galley lift sink systems. It has a special design that allows the faucet to remain intact when the galley s...
View full detailsGalley Kitchen Sink Faucet With Flex Spout
This faucet is a common replacement for galley lift sink systems. It has a special design that has a flex spout and quick connect to allow room for...
View full detailsGalley Knuckle Latch 2 Pack
Commonly used on galley sink lifts from 1994 till the end of production. This catch installs on the rear of the galley sink system. Other applicati...
View full detailsGalley Knuckle Latch Plastic
Commonly used on galley lifts. This plastic catch installs on the rear of the galley sink system and holds it in the up position. Other application...
View full detailsGalley Lift Bars Used
The galley lift bar is used to raise and lower the sink and stove system. This type of bar is always found on chain assist versions. Very common ...
View full detailsGalley Lift Catch
Found at the back of Galley lift system, this catch locks the galley into open position. Commonly called rooster catches and chicken catches due to...
View full detailsGalley Lift Hardware Kit 12 Inch Used
Hardware kit for the galley sink lift system. This kit has 12 inch bars that install inside the cabinet. Comes with everything shown. Part number 4...
View full detailsGalley Lift Hardware Kit 13 Inch Used
Hardware kit for the galley sink lift system. This kit has 13 inch bars that install inside the cabinet. Comes with everything shown. Part number 4...
View full detailsGalley Lift Hardware Kit 17 Inch Used
Hardware kit for the galley sink lift system. This kit has 17-1/8 inch bars that install inside the cabinet. Comes with everything shown. Part numb...
View full detailsGalley Lift Hardware Kit 8 Inch Used
Hardware kit for the galley sink lift system. Directly matched to the following camper. 1996 Shenandoah This kit has 8-5/8 inch bars that install...
View full detailsGalley Support Pole Used
Located on units with fold over galley sink and stoves. This bar is bolted to the side of the upper galley. It acts as a bar to raise and lower the...
View full detailsGas and Wire Clamps
Metal clamp to secure LP gas line routing. Part number 1201-8701
Gas One GS-3400P Propane or Butane Dual Fuel Stove
Duel Fuel - Compatible With Both Butane (Fuel Not Included) And Propane Fuel (Fuel Not Included), Operates On A Single Butane Cartridge 8 Oz Or A P...
View full detailsGazoodi 23X23
What in the world is a gazoodi? This is the dinette seat bench end that is always located opposite the wall. Directly matched to a 2006 E2. Series ...
View full detailsGazoodi 27X17
What in the world is a gazoodi? This is the dinette seat bench end that is always located opposite the wall. Directly matches to 2008 Destiny Sea P...
View full detailsGazoodi 40X23
What in the world is a gazoodi? This is the dinette seat bench end that is always located opposite the wall. Directly matched to a 2006 E2, Series ...
View full detailsGlass Fuse
Found in early Magnatek converter boxes. This cartridge-style, fast-acting glass fuses open within seconds of being exposed to overloads and short ...
View full detailsGlide Out and Countertop Seal 8 Foot
This seal is commonly used for slide out boxes. Two seals stacked together on each side of the slide out box act as a weather barrier. Other locat...
View full detailsGlide Out Bulkheads Used
Bulkheads for glide out, both left hand and right hand. Popular on Grand Tour series pop ups. Measures 28 inches tall by 4-1/8 inches wide with a 3...
View full detailsGlide Out Catch
Located under the glide out system, This catch locks to the front roller tower when the system is out. Measures 4 inches by 1-1/2 inches by 1-3/4 i...
View full detailsGlide Out Corner
Exterior corner trim kit for the glide out systems. Measures 35 inches long, by 1-5/8 inches by 1-3/8 inches. Part number 4772A8741
Glide Out Corner Kit
Exterior corner trim kit for the glide out systems. Series 3700 Sold as a pair. Measures 24-1/8 inches in length, by 1-5/8 inches by 1-1/2 inches. ...
View full detailsGlide Out Corner Kit Used
Exterior corner trim kit for the glide out systems. Directly compatible to the following unit 2000 Niagara Series 3495 Very popular on many other...
View full details