Coming Back Soon

The lift arm provides lift to the pop up. They are found in each corner of the camper. CSF / Curb Side Front RSR / Road Side Rear Videos availab...

Used to trim table and countertop sides. Sold in 12 foot length. Long enough to trim the largest table with one run. Choosing the correct size. Yo...

Used in crank assemblies, this washer has a slightly beveled edge for the shaft bushing. It's important to note the direction of this washer when r...

Attaches to the high pressure regulator to the copper line that runs to the exterior stove. 1/4 male MNPT fitting to 3/8 male flare. Measures 30 in...

The bed bow provides bunk end canvas support. This is the large U shaped pole that folds up from the beds and holds the canvas ends. This Click Loc...

Found on later model units, this roof corner cap kit will fit both the front or rear of the pop up campers roof. Comes with two corner caps, and ca...

The lift arm provides lift to the pop up. They are found in each corner of the camper. CSR / Curb Side Rear RSF / Road Side Front Videos availab...

Comes with strap and hardware. Strap measures 8-3/4 inches in length. Part number 4716-9691

This LP hose runs from the propane tank to the low pressure regulator. Acme nut to 1/4 inch inverted MPT. Hose measures 15 inches in length. The in...

The glide out bow provides end canvas support at the dinette. This is the large U shaped pole that folds up from the dinette and holds the canvas e...

White nylon strap with hook and loop Velcro to secure the shower cabinet top when lifted up. Comes with installation hardware. Measures 30 inches i...

Series 4100. 1/2 inch flared male fitting to 3/8 male. Measures 36 inches in length. Part number 4737-8871

Bracket for the pivot style bed support poles. This bracket installs under the bed frame, and pins the bed support pole that pivots down. Measures ...

Designed for Coleman and Fleetwood campers with ABS tops. This brace kit has a curved design to fit the plastic roofs that have experienced sagging...

Found on many Coleman and Fleetwood pop ups with galley lift system sinks. Installs to the bottom of the sink and connects to the drain hose. Measu...

This is one of the most common curtain clips found in Coleman and Fleetwood pop ups. It slides or snaps over the 5/8" curtain track found in many p...

Used to raise and lower the roof on Coleman's and Fleetwood's equipped with power lift systems. This remote plugs into the current limiter which is...

This stop bracket is installed at the ends of the top deck. One or two can be found at the front bed, and at the rear bed. The mounting screws for ...

Light up the campsite with this LED porch light. With on/off switch. 12 volt. 9 diode LED bulb included. Video available Featured in this video ...

This chain drive crank system is located behind the rear body panel, directly at center. This is the compression system and ratchet upper crank. Wh...

The shepherd's hook attaches to the bed bow and provides the center canvas support over the beds. King sized, this tent pole will fit most pop ups ...

The LUNA™ 400+ is a 2-in-1 design that is both practical and fun—a compact, rechargeable 400-lumen lantern plus a versatile multicolor string light...

Round drive design. The output shaft on this motor has a pin through it. Only two lift motors were used and they are easily identified by the shape...