Hardware

Angle brackets that position the battery box to the front frame of the camper. Comes with 2 brackets and installation rivets. Brackets measure 1-1/...

Series 3300 Measures 3-1/4 inches long by 3/4 of an inch wide. Part number 4755-2111

Located under the glide out system, This catch locks to the front roller tower when the system is out. Measures 4 inches by 1-1/2 inches by 1-3/4 i...

Roller tower for the glide out systems. Commonly found on larger Grand Tour and Highlander units. This 8 inch wide tower is one of four in this siz...

Roller tower for the glide out systems. Commonly found on larger Grand Tour and Highlander units. This 8 inch wide tower is one of four in this siz...

Roller tower for the glide out systems. Commonly found on larger Grand Tour and Highlander units. This tower is one of three in this size that faci...

Roller tower for the glide out systems. Commonly found on larger Grand Tour and Highlander units.  Frame measures 7-1/2 inches tall, 3-1/2 inches w...

Inner roller track for glide out systems. Found at the bottom left and right of the glide out system. Directly matched to the Somerset units with a...

Inner roller track for glide out systems. Found at the bottom left and right of the glide out system. Directly matched to the following unit 2000 ...

Metal box for the exterior shower box. This box covers the exterior shower box and the water line connections. Measures 12 inches by 7 inches by 5 ...

Finger pull handle for the grey storage box system found on later model Fleetwood's, and Somerset's. Install at the top lid. Most commonly installe...

Used to route water lines and power lines behind body panels and inside cabinets. Snap closure and self adhesive mounting pads makes installation e...

Located under the glide out system, this roller allows the slide action of the assembly. Installed in one of eight towers commonly. Measures 4-3/4 ...

Found at the glide out. This metal trim catches the lock bar from the glide out latches. Overall measurements are 4-1/4 inches wide by 1-1/8 inches...

Angle bracket to join seat frame sections. Here's an example of a seat frame. Measures 11 inches long by 3/4 of an inch on each side. Part number ...

Metal frame for under the bench dinette seats. Measures 42-7/8 inches wide by 21-3/4 inches tall. Part number 4759-6021-USED

Located inside the glide out box, this bracket mounts the grab handle. Two are found inside each glide out box. Measures 7-1/8 inches long, 1-1/2 i...

The cap is the metal bracket that mounts over the plastic front or rear body panel. Metal end rail with double sided tape installed on one side.  M...

The cap is the metal bracket that mounts over the plastic front or rear body panel. Metal end rail with double sided tape installed on one side.  P...

The end rail cap is the metal bracket that mounts on top of the front and rear body panels. This cap is installed most commonly with stainless stee...

Used on the sides of the slide outs. These pads are on the exterior of the glide-out and act as a wear pad. Commonly two are installed in a row. Me...

Used on the sides of the slide outs. These pads are on the exterior of the glide-out and act as a wear pad. Commonly two are installed in a row. Me...

Used on the sides of the slide outs. These pads are on the exterior of the glide-out and act as a wear pad. Commonly two are installed in a row. Me...

Used on the sides of the slide outs. These pads are on the exterior of the glide-out and act as a wear pad.  Measures 48 inches long by 4 wide. Par...