Hardware

Brass. Measures 3/8 of an inch across. Pack of two. Part number 0322A3301

Used to space the 20 inch steps to the frame rails on many units. Measures 5-1/2 inches by 1-1/2 inches. Part number 4750-3361

Mounting bracket to hold the shower wand. Installs in the shower stall or exterior shower compartment. Measures 2 inches at the base and 1-3/4 inch...

Holds the tent support poles with duck bill caps to the ceiling. Referred to the steel loop in the parts books, this can also be found for table br...

Commonly referred to as the "cooler clip" in the parts books. This small plastic clip typically secures the stove support rod in the stored positio...

Large C clip for swing down tongue jacks. These are the jacks that are mounted to the side of the pop ups A frame. Measures 2-5/8 inches in diamete...

Lower support bracket for the exterior tables and stoves. This bracket can be found on an exterior body panel, frame rail or inside a swing style d...

Button snap kit. 10 pack. Part number 2560102

Measures 2-1/2 inches in length. Part number 4754A4811

Spare tire mount kit for late 1970's Coleman utility equipment. 1/2 inch bolts measure 6 inches in length. Part number 4738A5361  

This bracket is found on ABS roofs that have had a curved roof brace installed. Installed on top of the roof, this bracket holds the carriage bolts...

I beam track stop. Measures 3/4 of an inch tall. Part number 4739-0671

Helps reduce the risk of slips and falls. This can be used in entry ways, steps and on platform risers into the beds. Self adhesive backing. Measur...

Trims rings are used to finish holes in body panels and bumpers for drive hub extensions. Commonly found in the rear body panel or rear bumper, roo...

Roof angle for the installation of vanity mate and camper caddie systems. designed primarily for filon tops   Measures 2-1/4 inches tall with a 2 i...

Storage bracket for the vanity mate system. Measures 1 inch tall with a 2-1/2 inch wide base. Part number 4757-0121

Attaches to the ceiling or side coves of the roof to hang a vanity mate or camper caddy. This bracket is also found on some units as outdoor stove ...

Washer painted white. 1-1/4" width. Part number 4749A1098

4 pack of weld pins and screws. Part number 4716-4591

Twin handles, one on each side of the slider. Part number 1225D4181

Bolts and lock nuts for the installation of the access door lock. Works on every installation, no matter the lock location. Part number 4716-056

On the top corners of the deck rails you can find these corner brackets. They cover the four corners of the top rails. Series 3300. Measures 1-7/8 ...

On the top corners of the deck rails you can find these corner brackets. They stack on top of each other, and cover the four corners of the top rai...

On the top corners of the deck rails you can find these corner brackets. This style is commonly found on Somerset pop up campers. Measures 2-1/4 in...