Prodotti

Plastic sink strainer crumb basket. Measures 1 inch tall. Part number 4714C0661

Located at the entryway to your pop up. This is attached to the floor, and commonly called the "screen door support" in your parts book. Measures 2...

Fits grey water drains. This cap also fits on the 5 gallon water jugs found in pioneer series pop ups. 3/4 inch inside thread with a 6-1/2 inch str...

Comes with strap and hardware. Strap measures 8-3/4 inches in length. Part number 4716-9691

Matching left and right used metal drawer guides. These are the guides that mount to the side of cabinet drawers and allow the smooth pull / push o...

Used in the drive hub extension tubes on Coleman and Fleetwood crank assemblies. This spacer sits between the spring and flat washer, acting as a t...

Popular on 1990's and early 2000's models. 12 volt interior ceiling lamp. Squared design with on/off switch and power port for auxiliary equipment ...

Holds the tent support poles with duck bill caps to the ceiling. Referred to the steel loop in the parts books, this can also be found for table br...

Used to trim cabinet sections together. This style and color is commonly found in units built through the 1990's Color = Elm Please select your len...

Used in upper crank assemblies, and the lower left hand chain drive system found on certain 12 foot box units. The crank assembly gears and mechani...

Used for folding wall systems in pop ups with indoor showers. Removed from a 1986 Plantation series Savannah. Please choose your length from the dr...

Fresh water tank for potable water. Measurements are 23-3/4 inches long, 13-1/8 inches deep, and 7-1/2 inches tall. Part number 4757B0521-USED

Commonly found next to galley lift systems. This block acts as a rest when the galley sink system is lowered. Some glide outs use this as a guide b...

This hinge pivots the fold over galley sink system in pop ups. It is found screwed to the front top of the galley countertop, and lowers the galley...

The tent pole attaches to the glide out bow and provides center canvas supports over the glide out. Tent support tip attaches to the bow and the du...

Bed sheet set in a green pattern. Included are... (1) Fitted sheet with elastic edges (1) Top sheet (2) Pillow cases Kings, queens and double siz...

Used to provide awning support from the awning end rail to the ground on original Coleman and Fleetwood awnings. This pole pins into the end of the...

Door guide track for the screen door. This track attaches to the ceiling, and the screen door guides run in the track.  Series 3100.This track work...

The J-hook kit holds down the 20lb LP gas bottles on the front of the pop up. 20LB tanks are the most common size on pop up campers. Comes with 2 J...

Crank cover for left hand chain drive lift systems. Found on 12 foot box models built between 2000 and 2002. Series 3500 Measures 13-1/4 inches wid...

A great addition to your pop ups accessories! These ultra-durable tumblers are made with kitchen grade 18/8 stainless steel with double walls vacuu...

Found at the four inside corners of the roof. This covers installs over the lift pocket. Some versions have Velcro the affix valance's around them....

Used to trim table and countertop sides. Sold in 12 foot length. Long enough to trim the largest table with one run. Choosing the correct size. Yo...

Series 4100. 1/2 inch flared male fitting to 3/8 male. Measures 36 inches in length. Part number 4737-8871