Prodotti

Roller tower for the glide out systems. Commonly found on larger Grand Tour and Highlander units. This 8 inch wide tower is one of four in this siz...

Roller tower for the glide out systems. Commonly found on larger Grand Tour and Highlander units. This 8 inch wide tower is one of four in this siz...

These wheeled carriers are typically found on units produced from 1967 to the 1990's. The track guides are attached to the top of the screen door b...

This latch is found on the sidewalls holding the roof closed, and storage box bins on pop up campers. Pulling down on the latch clamps the roof and...

This latch is found on the sidewalls holding the roof closed, and storage box bins on pop up campers. Pulling down on the latch clamps the roof and...

Latch brackets for the roof and storage compartment latches. Sold in a 2 pack with 4 screws. Measures 1-1/4 inches wide. Please select your color f...

Designed for Coleman and  Fleetwood campers with metal or filon tops. This brace could be required for an air conditioner installation or a sagging...

Designed for Coleman and  Fleetwood campers with metal or filon tops. This brace could be required for an air conditioner installation or a sagging...

Designed for Coleman and  Fleetwood campers with metal or filon tops. This brace could be required for an air conditioner installation or a sagging...

These brackets fit the the left hand and right hand ends of the 4800-4811 roof brace. They secure to the roof curtain and canvas tracks and hold th...

Designed for metal and filon roofs. This bracket kit is for units produced through 1980 to the 2000's. Video available Found in the following AC ...

Designed for metal and filon roofs. This bracket kit is for units produced through 1980 to the 2000's. Video available Found in the following AC ...

Roof brace cover. Cover measures 79-1/4 inches long by 5 inches wide. Removed from a 1986 Plantation series Savannah.    Video available Part num...

4 caps to replace all the corners on your Somerset or Fleetwood roof.  These are the later styled versions with grooves to accept the metal extrusi...

This roof cap end panel has interior brackets that are open on the bottom.  Measures 86-1/2 inches wide by 10-1/4 inches tall. This item is Shipped...

This roof cap end panel has interior brackets that are closed on the top and bottom.  Measures 86-1/2 inches wide by 10-1/4 inches tall. This item ...

Found on certain Grand Tour series roofs. This is a cap on the end of the roof at the rear of the pop up. Series 3800GT Measures 86-1/2 inches wide...

2004 Utah Grand Tour Series 3881 Measures 86-1/2 inches wide by 10-1/2 inches tall at the middle. This item is Shipped via UPS within the continent...

This is the 12 volt power harness for the interior lighting and power points if installed. It runs up one corner, commonly next to a lift pillar. M...

This is the bar that mounts to all original Coleman and Fleetwood roof mounted cross bars systems. They work with both riser tower designs for Pion...

Mounting bracket for roof mounted crossbar braces. This bracket installs on the inside of the roof. Used on roof rack systems on units produced aft...

Roof track end cap for the aluminum roofs with inset tracks. This cap terminates the front and rear of the tracks. Measures 1-5/8 in width and 1/2 ...

Roof support poles for your pop up camper are now available. Multiple uses: This product can be provide for the added piece of mind of a roof suppo...

Installs onto the roof and catches the roof latches when the camper is closed. Measures 3 inches in length, 1-3/16th inches tall and the mounting h...