Prodotti

Rear support bracket for the spare tire. Measures 24-1/2 inches tall by 6 inches wide. The studs for the spare tire mounts extend 6-1/2 inches. Par...

Rear support bracket for the spare tire.  Popular on 2000's Grand Tour series units. Measures 23-3/4 inches tall by 6-1/8 inches wide. Part number ...

Rear support bracket for the spare tire. Measures 19 inches tall by 3 inches wide. The bottom projection measures 5 inches long. Part number 4747-5...

Mounted to the inside of galley kitchen cabinet doors. This rack keeps herbs and spices neatly organized. Measures 12 inches wide by 2-1/4 inches d...

Castle style spindle nut with D washer and cotter pin. Fits 1 inch axles. Part number 4714-3068  

Spray-away is a self-storing, self-contained product that eliminates the need for a bulky garden hose. Easy to install and easy to use. No valves ...

Quick connect fitting for the exterior spray port. Accepts a 1/4 inch quick connect fitting in the front and a 3/4 inch female pipe thread fitting...

Comes with a one way check valve with 1/2” female fitting. UV and impact resistant. Video available Cutout dimensions are 2-1/2 inches round. Th...

Square drive coupler to attach the lift motor to the whiffle tree on newer units. This coupler works directly with our square drive lift motor foun...

Square drive design. Only two lift motors were used and they are easily identified by the shape of the drive coupling. This motor incorporates a "s...

The whiffle tree is the threaded rod mounted in the bottom of the pop up. A draw bar runs up and down the rod and pulls or releases the cables. Thi...

Accepts a 1-3/8" water fill hose. Comes complete with a vent. Direct replacement for Coleman and Fleetwood pop up fresh water fill hatches for olde...

Black squared plug cap. Plastic. Fits 1 inch by 1 inch openings. Part number 4506-9411

Commonly found on units from 1968 to the late 1980's. Video available Installation screws are available   Cutout dimensions are 3 inches round....

Installed at the lift pillars, this trim kit keeps weather and debris out of the lift arms and act as guides for the lift arms. Finding these trims...

The most common of all Coleman and Fleetwood stabilizer jacks. 17 inch reach with a single arm that lowers when cranked. Designed to mount on the f...

A slightly larger Coleman and Fleetwood stabilizer jack. This jack is designed for units that may have over-sized tires or an axle flip that has gi...

Looking for an easier tool to raise and lower your screw down stabilizer jacks? This long reach handle measures 14 inches to make this task much ea...

Extra Large stabilizer jack. These jacks were only used on a few units, and they were always the largest units. Popular on early model Highlander s...

Jack mounting bracket for Highlander series pop ups. Series 3600C Measures 8-1/8 inches wide by 5-1/8 inches long by 2-1/2 inches tall. Part number...

Jack support bracket for Destiny series pop ups. Measures 9-3/4 inches wide by 3 inches tall. Part number 4746-8761

Stackers leveling blocks. Ten to a pack stored neatly and compactly in their own carry case. This multi-use product can be used as a leveler, jack,...

Found in the upper lift arm stages. This clip helps secure the next stage cable to the pulley pin. It can also be used to clamp the stage and main ...