Prodotti

Joins the lead rails together on Dometic Trimline awnings. Comes with 2 channels and hardware. Two different length options are available.  8 inch ...

1 inch trim bushing. Primary application to the air conditioner power grommet in roof braces. This trim ring presses into the roof brace power wire...

Trims rings are used to finish holes in body panels and bumpers for drive hub extensions. Commonly found in the rear body panel or rear bumper, roo...

Replacement ball end for the Dometic Trim Line awning support poles. This is the ball that sits at the ends of the rafter and vertical support pole...

Allows the hook up of three low pressure quick connect appliances. Comes with protective weather caps. Part number 06-0946

This white latch secures parts in the open position. Swinging a door or lid to this latch and turning it latches it open. Can also be used to hold ...

Most commonly found at the inside of the roof to latch the screen door into down position. Other applications include outside stoves and anywhere a...

Television coax cable wall plate with 12 volt power point. Installs inside the pop up. Part number 4757A4881

One of the most common of all Coleman and Fleetwood jacks. 17 inch reach stabilizer jacks. Single arm design to mount on the four corners of most C...

A slightly larger Coleman or Fleetwood Stabilizer jack kit. This kit is designed for units that may have over-sized tires or an axle flip that has ...

This kit repairs small rips and tears on the sides, front and back panels of your Ultra Guard RV cover. The patch kit is compatible with all covers...

The Ultra Guard RV Pop-Up Camper Cover is designed to protect your pop up camper. It consists of a heavy-duty polypropylene fabric around the sides...

Commonly found in the dinette booth. This tank features a fill neck, breather tube fitting and one drain port on the bottom. Holds 10 gallons. Meas...

REPLACE DAMAGED OR OLD VENT LIDS WITH ONE, EASY-TO-INSTALL UNIVERSAL VENT LID The UNIMAXX Universal Vent Lid takes the hassle out of having to kno...

These bed rails works with almost every Coleman and Fleetwood pop up built prior to June 1997. Ready to install and set for most king sized beds an...

One of the two main lift cable types. This bolt end cable measures 225-3/4" long, and is sized for the largest sized box with this cable option. Ea...

The tent pole attaches to the glide out bow or tip out bow, and provides center canvas supports over the glide out or tip out. Comes with all possi...

Non piloted, can be used to build many different lengths of hinges. Measures 27 inches long by 2 inches wide. Part number 4773-8301

This knob should have you covered whether it's a replacement stove knob, or a hydraulic lift knob. Features a large knob that is sleeved to accept ...

This cable comes one end crimped and the other open to make a custom lift pillar cable. 1 Cable crimp for the open end is included. Measures 48 inc...

One of two main lift cable types. This loop end cable measures 250" long and is sized for the largest sized box with this cable option. Easily size...

Comes with a wide range of colors for both canvas and vinyl. Each patch measures at least 8 inches by 8 inches. Part number 4424-6001

The shepherd's hook attaches to the bed bow and provides the center canvas support over the beds. King sized, this tent pole style is a direct repl...

The shepherd's hook attaches to the bed bow and provides the center canvas support over the beds. King sized, this tent pole will fit most pop ups ...