Coming Back Soon

The lift arm provides lift to the pop up. They are found in each corner of the camper. CSF / Curb Side Front RSR / Road Side Rear Videos availab...

Used to trim table and countertop sides. Sold in 12 foot length. Long enough to trim the largest table with one run. Choosing the correct size. Yo...

Used in crank assemblies, this washer has a slightly beveled edge for the shaft bushing. It's important to note the direction of this washer when r...

The bed bow provides bunk end canvas support. This is the large U shaped pole that folds up from the beds and holds the canvas ends. This Click Loc...

Found on later model units, this roof corner cap kit will fit both the front or rear of the pop up campers roof. Comes with two corner caps, and ca...

The lift arm provides lift to the pop up. They are found in each corner of the camper. CSR / Curb Side Rear RSF / Road Side Front Videos availab...

Comes with strap and hardware. Strap measures 8-3/4 inches in length. Part number 4716-9691

The glide out bow provides end canvas support at the dinette. This is the large U shaped pole that folds up from the dinette and holds the canvas e...

White nylon strap with hook and loop Velcro to secure the shower cabinet top when lifted up. Comes with installation hardware. Measures 30 inches i...

Series 4100. 1/2 inch flared male fitting to 3/8 male. Measures 36 inches in length. Part number 4737-8871

Found on many Coleman and Fleetwood pop ups with galley lift system sinks. Installs to the bottom of the sink and connects to the drain hose. Measu...

This stop bracket is installed at the ends of the top deck on the sides. One or two can be found at the front bed, and at the rear bed. The mountin...

Used on Coleman and Fleetwood pop up with an upper or left hand crank assemblies. The chain runs from the crank assembly to this gear. This gear th...

The shepherd's hook attaches to the bed bow and provides the center canvas support over the beds. King sized, this tent pole will fit most pop ups ...

Roof support poles for your pop up camper are now available. Multiple uses: This product can be provide for the added piece of mind of a roof suppo...

The shepherd's hook attaches to the bed bow and provides the center canvas support over the beds. King sized, this tent pole style is a direct repl...

The shepherd's hook attaches to the bed bow and provides the center canvas support over the beds. King sized, this tent pole style is a direct repl...

Diamond plate metal wheel well.  Measurements included are of the wheel well body not the lips. Measures 23 inches wide, 12 inches deep, and 6 inch...

Found on direct drive crank assemblies. This plate sits inside the larger bearing plate, and stops the crank system from moving to far forward. A c...

The bed bow provides bunk end canvas support. This is the large U shaped pole that folds up from the beds and holds the ends. This Click Lock bed b...

Series 3300. 1/2 MNPT male fitting to 3/8 inch male flare. Measures 36 inches in length. Part number 4733A3991

Used to provide center canvas support. C clasp attaches to the bed bow, and the duck bill / ball cap attaches to the roof bracket. Designed for dou...

Designed for metal and filon roofs. This bracket kit is for units produced through 1980 to the 2000's. Video available Found in the following AC ...

The whiffle tree is the threaded rod mounted in the bottom of the pop up. A draw bar runs up and down the rod and pulls or releases the cables. Thi...