Roof

This track hangs the curtains, valances and canvas.  The top channel accepts the type C hangers for the valances. The middle track is set for type ...

2004 Utah Grand Tour Series 3881 Measures 86-1/2 inches wide by 10-1/2 inches tall at the middle. This item is Shipped via UPS within the continent...

The lift arm provides lift to the pop up. They are found in each corner of the camper. CSF / Curb Side Front RSR / Road Side Rear Videos availab...

The lift arm provides corner lift to the pop up. It works in two separate locations on the unit. CSR / Curb Side Rear RSF / Road Side Front Vide...

Found at the four inside corners of the roof. The lift arms attach to these lift pockets with two 1/4” nuts. Pro Tip : Install the two 1/4” lock n...

Found at the four inside corners of the roof. This covers installs over the lift pocket. Some versions have Velcro the affix valance's around them....

Found at the four inside corners of the roof. This covers installs over the lift pocket. Measures 5-1/2 inches wide by 4-3/4 inches tall. Part numb...

Found at the four inside corners of the roof. The lift arms attach to these lift pockets with two 1/4” lock nuts. Pro Tip : Install the two 1/4” l...

Found on 3 stage lift arms, this is the second section from the top. The arm location is RSF / CSR (Road Side Front - Curb Side Rear) The top brack...

Found on 4 stage lift arms, this is the second section from the top. The top bracket is where the pulley attaches. The bottom bracket for the stage...

Found on 3 stage highwall lift arms, this is the bottom section. Highwall units typically have body panels that measure 28 inches in height. The to...

Installs at the ceiling under the duck bill support bracket. This pad creates friction for the duck bill, helping keep the tent support pole in pla...

Roof track end cap for the aluminum roofs with inset tracks. This cap terminates the rear of the tracks. Measures 1-5/8 in width and 1-1/2 inch in ...

Nylon straps with snap buttons to hold the shower rod to the ceiling. Lengths can differ with the strap location. One ABS roofs, closer to the roof...

Fits Yakima roof mounted bike and cargo rack systems. This cap installs at the ends of the crossbars, giving them a clean look. Series 3800 Part nu...

Used with roof mounted Yakima crossbar systems. Measures 2-1/4 inches tall. Part number 4743-4281

Yakima rail rider towers for roof mounted rail systems. These towers accept into inset C channels built into some roofs, always metal or filon roof...

Used with roof mounted Yakima crossbar systems. Measures 6" X 4" X 2" Part number 4906-5079

Used with roof mounted Yakima crossbar systems. Measures 7-3/4" X 2" X 2" Part number 4906-4809

Used with roof mounted Yakima crossbar systems. Measures 16" X 4-1/2" Part number 4742-9011

Designed for Coleman and  Fleetwood campers with metal or filon tops. This brace could be required for an air conditioner installation or a sagging...