coleman pop up parts

These are found fastened on top of the body panels, located towards the center. They assist in guiding the bed extensions up and back into the camp...

Installed on the top of the front and rear body panel rails. Acts as a rest for the bed extensions. These caps are found on the left and right, dir...

Mounting screw for the bed rest and bed slide ramps. Measures 1-1/4 inches in length. Part number 4800-2794

Found on units produced after 1997. This bracket rivets to the sides of the bed frame, and mounts the bed roller through the center hole. Here is a...

Bed roller wheel and bracket for pre 1997 Coleman and Fleetwood pop ups. This is the roller wheels that rivet to the side of the bed. Two of these ...

This seal installs into the small track at the ends of the beds, on both the inside and outside of the bed extensions. Video available Pop ups wi...

Bed slide stop bracket. This stop bracket is installed into the side rail. Found mostly commonly on Americana and Destiney series units. Plastic. M...

The bed slide wedge is found on the inside of the bed rails on Fleetwood pop ups built after 1998. Installed on the inside of each rail they help k...

Right angle bed slide stop bracket. Located at the top of the front and rear body panels on many Coleman and Fleetwood pop ups. This bracket can ca...

Reinforcement bracket for bed slide stop. Measures 4 inches wide, 1 inch tall on the side with two holes, 3/8 of an inch tall on the side with 3 ho...

This bracket attaches to the rear of the trailer and holds the bed support poles when in use. Comes with bracket, guide spacers, guide bolt and nut...

This style of bed support pole is commonly found on units produced up to the 2000’s. After that some smaller box sized Coleman and Fleetwood also u...

This style of bed support pole is commonly found on units produced up to the 2000’s. After that some smaller box sized Coleman and Fleetwood also u...

This bed support pole is commonly found on units produced after the 2000's. This is the pole that stabilizes the bed. Two are found under each bed ...

This bed support pole is commonly found on units produced after the 2000's. This is the pole that stabilizes the bed. Two are found under each bed ...

This bed support pole is commonly found on the following Coleman and Fleetwood series pop ups. Highlander Evolution This is the pole that stabili...

Used to trim table and countertop sides. Sold in 12 foot lengths. Long enough to trim the largest table with one run. Choosing the correct size. Y...

Metal frame for under the bench dinette seats. Measures 42-7/8 inches wide by 21-3/4 inches tall. Part number 4759-6021-USED

Metal frame for under the bench dinette seats. Found in many 1980's units. Measures 39-1/4 inches wide by 21-3/4 inches tall. Part number 4741D573-...

Metal frame for under the bench dinette seats. Found in many 2000's models. Measures 42-7/8 inches wide by 21-3/4 inches tall. Part number 4767-586...

Found under the pull out bench / bed systems. Different sizes to choose from. Please select your size from the drop down menu.  

Keep buzzing bees and other pesky insects out of your drinks with Can Caps! The Can Cap attaches easily to most soft drink and adult beverage cans...

Lower pivot bracket for the bed bow. This bracket installs at the left and right of the bed extension. Video available Measures 2-1/2 inches lon...