coleman pop up parts

Mounting bracket for the thermostat. Located behind the plastic base that the thermostat is installed into. This bracket mount it to the inside of ...

This mounting base is located behind the furnace thermostat. Tan in color. Measures 6-5/8 inches outside square and 5 inches inside square. Part nu...

2 wire harness for the Atwood Hydroflame furnace thermostat. Measures 34 inches in length. Part number 4750A6431

In model year 1999 this new thrust bearing was introduced into production. It directly replaced the 3000 series thrust bearing, and was installed o...

This bearing is found on later model units at the thrust nut coupler. Here is an example of the coupler that this bearing works with. Video avail...

This bearing is one of the most common thrust bearings found on units from the 1970's through the 1990's It is found on units that have upper crank...

This bearing is located at the end of the 4759-6311 direct drive crank assembly. It rides on the end of the driveshaft and rests in the bearing hou...

This drive coupler is found in late model units. It acts as a bearing spacer and coupler bushing. Measures 3 Inches tall. Part number 4759-0381

Installs on the whiffle tree and holds the 3000 series thrust bearing. Most commonly used on units with chain driven lift systems. Dimensions are 2...

Installs at the end of the 3000 series direct drive crank assembly. It works as a whiffle tree coupler, and holds the 3000 series thrust bearing. D...

The tip out bow provides canvas support over the tip outs at the galley kitchen. 2 tent support tips mount the bow. Measures 46 inches wide by 47 i...

The tip out bow provides canvas support over the tip outs at the galley kitchen. 2 tent support tips mount the bow. Measures 51 inches wide by 44-1...

A tent support tip provides center canvas support for the tent support pole. 2 tent support tips mount the bow. Measures 52 inches wide by 52 inche...

This set installs at the tip out, and has a valance sew to them. The kits installs with two snaps at each corner. The center hoop is where the tent...

This tent pole attaches to the tip out bow and provides center canvas supports over the tip out. Tent support tip attaches to the bow and the duck ...

This shelf attaches to the tip out bow at the dinette and provides a fold down shelf. Makes a great place for today's cell phones. Directly matched...

This panel is found at the galley sink area on units with tip outs. Measures 51-1/8 inches by 8-1/2 inches. Part number 4755-0971

This panel is found at the galley sink area on units with tip outs. Directly matched to the following units. 2005 Americana Rushmore series 3950 2...

Protect your tires from sun damage with these covers from Classic. Trailer tire sidewalls are thinner than automobile tires and this makes them mor...

This bolt kit installs at the rear of many Coleman and Fleetwood pop ups. They extrude from the rear body panel and are installed into a spare tire...

Spare tire mount kit for late 1970's Coleman utility equipment. 1/2 inch bolts measure 6 inches in length. Part number 4738A5361  

This bolt kit installs at the rear of many Coleman and Fleetwood pop ups. They extrude from the rear body panel and are installed into a spare tire...

Not only marshmallows get toasted at the campfire! Featuring original chalk artwork by Derek Smith. This self adhesive sticker will look great on y...