
Drive Hub Extension Washer
Used in every drive hub extension tube.
Commonly two are installed. These are a very thin thrust washer.
Measures 15-16th inches wide. 1/2 inch inside opening.
Part number 4757-3938
Used in every drive hub extension tube.
Commonly two are installed. These are a very thin thrust washer.
Measures 15-16th inches wide. 1/2 inch inside opening.
Part number 4757-3938
Used in the drive hub extension tubes on Coleman and Fleetwood crank assemblies. This spacer sits between the spring and flat washer, acting as a t...
Visualizza tutti i dettagliThis spring is found inside the drive hub extension tube. The original springs were a simpler design, typically a coil spring. This wave spring dir...
Visualizza tutti i dettagliThis 5/8 nut threads onto the end of fine thread drive shafts. This is the final nut found on the end of drive shafts for crank assemblies. Early v...
Visualizza tutti i dettagliThe drive hub extension threads onto the drive shaft. This crank component is what you see sticking out of the camper, and what you put the crank h...
Visualizza tutti i dettagliThe drive hub pin is most commonly found installed at the end of drive hub extension. This is the pin that the crank handle grabs onto in order to ...
Visualizza tutti i dettagli0 di 3 elementi selezionati
Seleziona il primo elemento da confrontare
Seleziona il secondo elemento da confrontare
Seleziona il terzo elemento da confrontare