Produtos

Used on coleman and Fleetwood pop up with an upper or left hand crank assemblies. The chain runs from the crank assembly to this gear. This gear th...

Power outlet for 15 amp service. This style, the power wires pass straight through the back of the outlet. Comes with outlet, backing and faceplate...

Used on many chain driven crank assemblies. This gear drives the 12 tooth gear, and is found in many upper cranks and left hand cranks. Some versio...

Upgrade to LED marker lights!  LED bulbs last longer, are brighter, and use less electricity. This lamp replaces the entire assembly. White and bla...

The lift arm provides lift to the pop up. They are found in each corner of the camper. CSF / Curb Side Front RSR / Road Side Rear Videos availab...

Air conditioner roof brace mounting bracket. Series 3800, 4396, 4391 and 4389 Measures 3 inches in overall length by 1-1/2 inches wide. Part numbe...

Designed for most Coleman Fleetwood campers with ABS tops. This brace kit has a curved design to fit the plastic roofs that have experienced saggin...

Air conditioner power cord with 20 amp plug. Comes with enough cord to fit the largest possible pop up. Part number 4748A6591

This lens work with this style porch lamp. Two mounting tabs on the bottom and one on the top. Measures 5-3/8 inches in length, 2-3/8 inches tall....

Specifically designed for pop ups. Comes with a low pressure auto changeover and two 15 inch acme nuts. The kit does not come pre assembled, consid...

Looking for quick relief from the hot afternoon sun? The A&E Systems Trim Line patio awning installs easily on your camper's awning rail, provi...

Looking for quick relief from the hot afternoon sun? The A&E Systems Trim Line patio awning installs easily on your camper's awning rail, provi...

Lower pivot bracket for the bed bow. This bracket installs at the left and right of the bed extension. Series 3600. Video available Measures 2-3/...

This is the channel that bolts to the bottom of the beds, and the bed support pole slides in. This complete kit is ready to accept your bed support...

Installed on the top of the front and rear body panel rails. Acts as a rest for the bed extensions. Mounting hardware is available Measure 1-1/2" ...

This style of bed support pole is commonly found on units produced up to the 2000’s. After that some smaller box sized Coleman and Fleetwood also ...

This style of bed support pole is commonly found on units produced up to the 2000’s. After that some smaller box sized Coleman and Fleetwood also u...

This bed support pole is commonly found on the following Coleman and Fleetwood series pop ups. Destiny Grand Tour Highlander Evolution Scorpion T...

This bed support pole is commonly found on the following Coleman and Fleetwood series pop ups. Destiny Grand Tour Highlander Evolution Scorpion T...

Rivet hardware kit for the installation of this style of bumper caps.   10 rivets are included, 8 are required for the installation of two caps. P...

Stove support bracket for exterior stoves, grills, and tables. This is the rail that attaches to the side of your Coleman or Fleetwood pop up. Mea...

12 volt ceiling lamp with a white plastic lens. Add a pack of light bulbs to your order here Measures 6-1/2 inches long by 4-1/2 inches wide. Part ...

Dome light lens. Measures 4-7/8 inches squared. Directly matched to the this ceiling lamp, lamp part number 4737E5911. Part number 4714D0891

The bed bow provides bunk end canvas support. This is the large U shaped support pole that folds up from the beds and supports the canvas ends. Thi...