Produtos

Attaches to the high pressure regulator to the copper line that runs to the exterior stove. 1/4 male MNPT fitting to 3/8 male flare. Measures 30 in...

This track hangs the curtains, valances and canvas.  The top channel accepts the type C hangers for the valances. The middle track is set for type ...

Metal exterior drain nut. This jam nut is found on the outside sink drains on many Coleman and Fleetwood pop ups. Direct replacement for the plasti...

Installs on the whiffle tree and holds the 3000 series thrust bearing. Most commonly used on units with chain driven lift systems. Dimensions are 2...

Found inside the track rails for pre-1997 bed extensions that use bed rails with roller wheels. Two small pins and double sided automotive tape hol...

Found inside the slide track rails for pre-1997 bed extensions that use bed rails with roller wheels. This track acts as a guide for the bed rails....

Found on units built before 1997 that use roller style bed rails. This pin in installed in the top deck rail, and acts as a stop for the wheels and...

Used in crank assemblies, this washer has a slightly beveled edge for the shaft bushing. It's important to note the direction of this washer when r...

Measures 3 inches wide by 3 inches tall. Part number 4799C8642

Located just past the whiffle tree. This separator bracket is used to mount the 4 lift system pully's and guide the cables out from the whiffle tre...

The ratchet pawl is part of the mechanical brake for most lift systems. This cam engaging the ratchet wheel sprocket is what gives the Coleman and ...

Plastic refer vent is found on many pop ups campers. Some larger units use two vents, one stacked above the other.  Directly matched to the followi...

Used in pre-1997 bed rails. Spaces the roller wheels out further if required. Some units require up to 3 roller spaces between the bed frame and th...

Installed onto the roof and storage box lids, and catches the latches when the lid is closed. Measures 2 inches in length, 1-3/16th inches tall and...

These brackets fit the the left hand and right hand ends of the 4800-4811 roof brace. They secure to the roof curtain and canvas tracks and hold th...

Found on later model units, this roof corner cap kit will fit both the front or rear of the pop up campers roof. Comes with two corner caps, and ca...

The roof seal installs into a channel inside, or on the bottom of the roof. The size of the track that the beads accepts into is 3/8 inch. Coleman ...

This lens is solid red. No bottom tag illumination. The top center is clear for reverse lights. Dimensions are 8 1/2 inches wide by 4 1/2 inches ta...

Used on every Coleman and Fleetwood crank assembly that uses a drive hub extension tube. This collar installs in the front crank housing plate. The...

This latch is found on units where the access door lock sits to the side of the door, mounted in a body panel. Always found on access doors that sw...

White nylon strap with hook and loop Velcro to secure the shower cabinet top when lifted up. Comes with installation hardware. Measures 30 inches i...

Easy DIY bendable shower track kit for your camper. This kit features an easy to bend track that can be hung or mounted directly to the ceiling. Th...

This hose connects to the interior or exterior shower valve, then to the shower wand. 60 and 72 inch lengths available. Please select your size fro...

Sold individually and in ten packs. Two types of rivets are most commonly used in pop up campers. Pop Rivets and Expansion Rivets. Pop Rivets are d...