Produtos

This housing covers the thrust bearing. It is used on almost every Coleman and Fleetwood pop up camper. Bolt it directly to the crossmember or fram...

Square spacer bearing retainer housing. Used in 6311 lower direct drive crank assemblies. Measures 2 inches by 2 inches squared. 9-16th of an inch ...

Used at the end of some direct drive crank assemblies.  Measures 2-1/2 inches by 2-1/2 inches. 1 inch inside diameter hole. Part number 4756-8321

Used to reinforce or space the thrust bearing. Measures 4 inches wide and 2-3/4 inches tall. 1-1/2 inch diameter hole. Color : Black Part number 47...

Grey Evolution canvas with a blue border. Directly matched to the following units 1992 Grandview series 2684 1992 Sequoia series 2610 1992 William...

Lower pivot bracket for the bed bow. This bracket installs at the left and right of the bed extension. Series 3600. Video available Measures 2-3/...

A common fail point for Coleman and Fleetwood pop up camper bed bows are right in the middle. This kit is designed to fix bed bows that have suffer...

Commonly found at the bed bow mounting bracket.  This washer acts as a wear spacer between the brackets and the bow. Measures 1-1/2 inches in width...

Bed frame sections for the pull out beds. This twin kit replaces the sides of the bed frame. Directly compatible to the following unit and location...

Bed frame sections for the pull out beds. This twin kit replaces the sides of the bed frame. Directly compatible to the following unit and location...

Bed frame sections for the pull out beds. This twin kit replaces the sides of the bed frame. Directly compatible to the following unit and location...

Slider channel hardware kit for the bed support pole. This hardware kit replaces the pins and hardware on slotted slider support channels.  Videos...

This is the channel that bolts to the bottom of the beds, and the bed support pole slides in. This complete kit is ready to accept your bed support...

This is the channel that bolts to the bottom of the beds, and the bed support pole slides in. The slider portion of these channels can warp, making...

Found under the bed extension, these clips hold the bed leg poles up under the beds when stored.  Measures 1-11/16th inches across. 7/8 of an inch ...

Found under the bed extensions, these clips hold the bed leg poles up under the beds when stored.  Measures 5/8 of an inch wide by 3 inches long.  ...

Green bed privacy panels with white mesh top. Designed for the bed areas. These curtains install to the tracks above the beds, and close off the be...

Make pulling out the beds a breeze with this kit! These pull handles can install on all pop up camper bed extensions. They make controlling the bed...

This end cap is found at the end of the bed rails on Fleetwood pop ups built after 1998. It is attached with a single bolt and nut to the end of th...