Produtos

This is the channel that bolts to the bottom of the beds, and the bed support pole slides in. This complete kit is ready to accept your bed support...

Found under the bed extension, these clips hold the bed leg poles up under the beds when stored.  Measures 1-11/16th inches across. 7/8 of an inch ...

Found under the bed extensions, these clips hold the bed leg poles up under the beds when stored.  Measures 5/8 of an inch wide by 3 inches long.  ...

Make pulling out the beds a breeze with this kit! These pull handles can install on all pop up camper bed extensions. They make controlling the bed...

This cap is found at the end of the bed rails on Fleetwood pop ups built after 1998. It is attached with a single bolt and nut to the end of the be...

Tapered machine bolt and locking nut for the bed slide wedge and bed rail end cap. Works on units produced after 1998. Part number 1201A1101

This wheel fits 1997 and prior Coleman and Fleetwood bed rails. The roller wheel sits at the front of the rail and acts as guide for the bed extens...

This wheel is commonly found on units built prior to 1997. The roller wheel sits at the front of the rail and acts as guide for the bed extension s...

Shoulder bolt and nut for bed rail wheels. These are found on the bed system in units built after 1998. 16 in total can be found on your camper. 8 ...

These are found fastened on top of the body panels, located towards the center. They assist in guiding the bed extensions up and back into the camp...

Installed on the top of the front and rear body panel rails. Acts as a rest for the bed extensions. These caps are found on the left and right, dir...

Mounting screw for the bed rest and bed slide ramps. Measures 1-1/4 inches in length. Part number 4800-2794

Found on units produced after 1997. This bracket rivets to the sides of the bed frame, and mounts the bed roller through the center hole. Here is a...

This seal installs into the small track at the ends of the beds, on both the inside and outside of the bed extensions. Video available Pop ups wi...

This stop bracket is installed at the ends of the top deck. One or two can be found at the front bed, and at the rear bed. The mounting screws for ...

The bed slide wedge is found on the inside of the bed rails on Fleetwood pop ups built after 1998. Installed on the inside of each rail they help k...

Right angle bed slide stop bracket. Located at the top of the front and rear body panels on many Coleman and Fleetwood pop ups. This bracket can ca...

Reinforcement bracket for bed slide stop. Measures 4 inches wide, 1 inch tall on the side with two holes, 3/8 of an inch tall on the side with 3 ho...

This bracket attaches to the rear of the trailer and holds the bed support poles when in use. Comes with bracket, guide spacers, guide bolt and nut...

This style of bed support pole is commonly found on units produced up to the 2000’s. After that some smaller box sized Coleman and Fleetwood also u...

This style of bed support pole is commonly found on units produced up to the 2000’s. After that some smaller box sized Coleman and Fleetwood also u...

This is the pole that stabilizes the bed. Two are found under each bed frame in these series. When the bed is pulled out, the pole swings down to t...