Produtos

The dual sized threaded fittings make choosing the right size a snap. This valve will replace most fresh water tank drain valves. Two sized threade...

Roller strike latch for cabinet doors. Keeps drawers and cabinet doors closed. 2 pack 5-6 lbs. Pull Force Finished in Nickel Strike Dimensions: 1...

Located most commonly on cabinet drawers that use Delta guides with center metal tracks. These corner rollers either screw or staple to the inside ...

Plastic guide socket for the drawer slides. Comes as a kit with hardware. Measures 2-3/4 inches across the mounting base. Part number 4749-8361

Matching left and right drawer guides. Found attached to the sides of the drawers on many models. These rails accept into plastic mounts located sc...

Matching left and right used metal drawer guides. These are the guides that mount to the side of cabinet drawers and allow the smooth pull / push o...

Roller catch for cabinet doors and drawers or anywhere a friction roller is needed. Comes in a pack of two. Included are 2 rollers, 2 catches, and ...

Matching left hand and right hand drawer sockets. Located inside cabinets, these plastic mounts are found screwed to the interior paneling.  The me...

Typically found on exterior stove pull outs and inside large cabinet drawers. Mounts on 1-1/8 inch holes. Part number 4744B5851-USED

The drive hub extension threads onto the drive shaft. This crank component is what you see sticking out of the camper, and what you put the crank h...

The drive hub extension threads onto the drive shaft. This crank component is what you see sticking out of the camper, and what you put the crank h...

The drive hub extension threads onto the drive shaft. This crank component is what you see sticking out of the camper, and what you put the crank h...

The drive hub extension threads onto the drive shaft. This crank component is what you see sticking out of the camper, and what you put the crank h...

This spring is found inside the drive hub extension tube. The original springs were a simpler design, typically a coil spring. This wave spring dir...

Used in every drive hub extension tube. Commonly two are installed. These are a very thin thrust washer.  Measures 15-16th inches wide. 1/2 inch in...

The drive hub pin is most commonly found installed at the end of drive hub extension. This is the pin that the crank handle grabs onto in order to ...

Used in the drive hub extension tubes on Coleman and Fleetwood crank assemblies. This spacer sits between the spring and flat washer, acting as a t...

The drive shaft bushing is found installed into the crank mounting plate. This bushing holds the rear of the drive shaft. Inserts into a 1 inch mou...

Double lamp ceiling light with on/off switch. Popular in later models such as the Highlander and Evolution series. Replacement 904 bulbs are availa...

Popular on 1990's and early 2000's models. 12 volt interior ceiling lamp. Squared design with on/off switch and power port for auxiliary equipment ...

Base plate mounting kit to add a second LP tank. Installs on top of the pop up A frame. Measures 37-1/4 inches across the top, 28-1/2 inches across...

An easy upgrade kit for adding two propane tanks. This kit mounts to the trailer tongue, and holds two 20 pound LP tanks. Comes with base, threaded...

Allows the hook up of two low pressure quick connect appliances. Comes with protective weather caps. Part number 06-0944

Commonly found on the largest units with dual sinks. Thin walled ABS 1-1/2 inch dual tailpiece. Measures 10 inches wide by 8-1/4 inches tall. Part ...