Produtos

Commonly used on galley sink lifts from 1994 till the end of production. This catch installs on the rear of the galley sink system. Other applicati...

Commonly used on galley lifts. This plastic catch installs on the rear of the galley sink system and holds it in the up position. Other application...

The galley lift bar is used to raise and lower the sink and stove system. This type of bar is always found on chain assist versions. Very common ...

Found at the back of Galley lift system, this catch locks the galley into open position. Commonly called rooster catches and chicken catches due to...

Hardware kit for the galley sink lift system. This kit has 12 inch bars that install inside the cabinet. Comes with everything shown. Part number 4...

Hardware kit for the galley sink lift system. This kit has 13 inch bars that install inside the cabinet. Comes with everything shown. Part number 4...

Hardware kit for the galley sink lift system. This kit has 17-1/8 inch bars that install inside the cabinet. Comes with everything shown. Part numb...

Hardware kit for the galley sink lift system. Directly matched to the following camper. 1996 Shenandoah This kit has 8-5/8 inch bars that install...

Located on units with fold over galley sink and stoves. This bar is bolted to the side of the upper galley. It acts as a bar to raise and lower the...

Metal clamp to secure LP gas line routing. Part number 1201-8701  

Duel Fuel - Compatible With Both Butane (Fuel Not Included) And Propane Fuel (Fuel Not Included), Operates On A Single Butane Cartridge 8 Oz Or A P...

What in the world is a gazoodi? This is the dinette seat bench end that is always located opposite the wall. Directly matched to a 2006 E2. Series ...

What in the world is a gazoodi? This is the dinette seat bench end that is always located opposite the wall. Directly matches to 2008 Destiny Sea P...

What in the world is a gazoodi? This is the dinette seat bench end that is always located opposite the wall. Directly matched to a 2006 E2, Series ...

Found in early Magnatek converter boxes. This cartridge-style, fast-acting glass fuses open within seconds of being exposed to overloads and short ...

This seal is commonly used for slide out boxes. Two seals stacked together on each side of the slide out box act as a weather barrier.  Other locat...

Bulkheads for glide out, both left hand and right hand. Popular on Grand Tour series pop ups. Measures 27-7/8 inches tall by 4-1/8 inches wide with...

Located under the glide out system, This catch locks to the front roller tower when the system is out. Measures 4 inches by 1-1/2 inches by 1-3/4 i...

Exterior corner trim kit for the glide out systems. Measures 35 inches long, by 1-5/8 inches by 1-3/8 inches. Part number 4772A8741

Exterior corner trim kit for the glide out systems. Very popular on many other grand tour series units. Comes complete with both left and right cor...

Exterior corner trim kit for the glide out systems. Directly compatible to the following unit 2000 Niagara Series 3495 Very popular on many other...

Metal end cap for glide out systems. Series 3500 Measures 71 inches long by 1-3/4 inches tall by 2 inches wide. Part number 4757B2161

Found at the front corner of the glide out, or nearest the tongue.  Measures 24-5/8 inches long, by 1-1/2 X 1-5/8 inches. Part number 4756B3361

Found at the front corner of the glide out, or nearest the tongue. Series 3378 and 3395 Measures 27-1/2 inches long, by 1-3/8 X 1-3/4 inches. Part ...