Crank Assemblies

We've cut them to the correct size for you! These bolt end cables are designed for Coleman and Fleetwood pop ups built after 1999.  How to install ...

This chain drive crank system is commonly located behind a rear body panel. This is the compression system and ratchet upper crank. When you turn t...

The most common of all Coleman and Fleetwood pop up crank handles. This handle works on almost all units with original equipment drive shafts and d...

Used in upper crank assemblies, and the lower left hand chain drive system found on certain 12 foot box units. The crank assembly gears and mechani...

This 5/8 nut threads onto the end of coarse thread drive shafts. This is the final nut found on the end of drive shafts for crank assemblies. Early...

Used in crank assemblies, this washer has a slightly beveled edge for the shaft bushing. It's important to note the direction of this washer when r...

Installs on the whiffle tree and holds the 3000 series thrust bearing. Most commonly used on units with chain driven lift systems. Dimensions are 2...

This cover bolts to the bottom of the whiffle tree system and adds stability to the lift system. Measures 32-1/4 inches long by 11-1/4 inches wide....

Located just past the whiffle tree. This separator bracket is used to mount the 4 lift system pully's and guide the cables out from the whiffle tre...

Crank cover for left hand chain drive lift systems. Found on 12 foot box models built between 2000 and 2002. Series 3500 Measures 13-1/4 inches wid...

Used in the drive hub extension tubes on Coleman and Fleetwood crank assemblies. This spacer sits between the spring and flat washer, acting as a t...

The ratchet pawl is part of the mechanical brake for most lift systems. This cam engaging the ratchet wheel sprocket is what gives the Coleman and ...

Used on every Coleman and Fleetwood crank assembly that uses a drive hub extension tube. This collar installs in the front crank housing plate. The...

Used to reinforce or space the thrust bearing. Measures 4 inches wide and 2-3/4 inches tall. 1-1/2 inch diameter hole. Color : White Part number 47...

Used on Coleman and Fleetwood pop up with an upper or left hand crank assemblies. The chain runs from the crank assembly to this gear. This gear th...

The lift arm provides lift to the pop up. They are found in each corner of the camper. CSR / Curb Side Rear RSF / Road Side Front Videos availab...

Found on 3 stage highwall lift arms, this is the bottom section. Highwall units typically have body panels that measure 28 inches in height. The to...