Products

The whiffle tree is the threaded rod mounted in the bottom of the pop up. A draw bar runs up and down the rod and pulls or releases the cables. The...

Quick loading Reese ball mount features an angled cut design.  1 inch ball shank hole size. 2 inch receiver tube. 6 thousand pound rating.  Class 3...

Barbed adapter to join two sections of the same sized water lines together. 3/8 and 1/2 inch sizes available. Clamps are available Please select ...

Group 24 battery box. Fits the most common of all pop up deep cycle batteries. Sometimes campers can have other group batteries. Checking the group...

Angle brackets that position the battery box to the front frame of the camper. Comes with 2 brackets and installation rivets. Brackets measure 1-1/...

This strap wraps around the battery box and lid which secures the battery box to the camper frame. Measures 54 inches in length. Part number 1490141

Unique to the Contour Battery Master Switch is the patented contour lock system which allows the switches to be used as stand alone units or locked...

These breakers can commonly be found on the battery harness, on the HOT or (+) side. For Coleman and Fleetwood pop ups, the common sizes pre instal...

Designed to repair broken 12 volt battery harnesses. Comes with both sides of the battery connections, along with crimp able connectors for easy re...

Designed for pop ups with one to three 12 volt appliances. Connects the 12 volt battery to the factory harness on Coleman and Fleetwood pop up camp...

Designed for larger pop ups with 4 or more 12 volt appliances. Connects the 12 volt battery to the factory harness on Coleman and Fleetwood pop up ...

No more disposable cylinders. High-pressure hose with adapter for use with high pressure gas grills.  Male P.O.L. x 1"-20 Throwaway Cylinder Thread...

Low pressure hose kit for Coleman sidekick low pressure grills. Comes with everything you need to connect your Sidekick grill to the low pressure q...

The perfect accessory for a day at the beach or the pool. The towel features a decorative RV pattern design and is made of 100% cotton. It measure...

This housing covers the thrust bearing. It is used on almost every Coleman and Fleetwood pop up camper. Bolt it directly to the crossmember or fram...

Square spacer bearing retainer housing. Used in 6311 lower direct drive crank assemblies. Measures 2 inches by 2 inches squared. 9-16th of an inch ...

Found on direct drive crank assemblies. This plate sits inside the larger bearing plate, and stops the crank system from moving to far forward. A c...

Located at the rear of the bed slides on many models, this tracks hold the bottom of the bed boot to the bed frame. The most common installation me...

Lower pivot bracket for the bed bow. This bracket installs at the left and right of the bed extension. It installs with two pop rivets and one wood...

A common fail point for Coleman and Fleetwood pop up camper bed bows are right in the middle. This kit is designed to fix bed bows that have suffer...

Commonly found at the bed bow mounting bracket.  This washer acts as a wear spacer between the brackets and the bow.  Plastic fender washer.Measure...

Bed frame section for 1990's Destiny series units. Measures 47-5/8 inches long by 2-1/2 inches tall. Part number 4747-3231 

Bed frame sections for the pull out beds. This twin kit replaces the sides of the bed frame. Directly compatible to the following unit and location...

Bed frame sections for the pull out beds. This twin kit replaces the sides of the bed frame. Directly compatible to the following unit and location...