Produkte

Found on later model units, this roof corner cap kit will fit both the front or rear of the pop up campers roof. Comes with two corner caps, and ca...

This is the bar that mounts to all original Coleman and Fleetwood roof mounted cross bars systems. They work with both riser tower designs for Pion...

This lens is solid red. No bottom tag illumination. The top center is clear for reverse lights. Dimensions are 8 1/2 inches wide by 4 1/2 inches ta...

Used on every Coleman and Fleetwood crank assembly that uses a drive hub extension tube. This collar installs in the front crank housing plate. The...

This latch is found on units where the access door lock sits to the side of the door, mounted in a body panel. Always found on access doors that sw...

White nylon strap with hook and loop Velcro to secure the shower cabinet top when lifted up. Comes with installation hardware. Measures 30 inches i...

Easy DIY bendable shower track kit for your camper. This kit features an easy to bend track that can be hung or mounted directly to the ceiling. Th...

Sold individually and in ten packs. Two types of rivets are most commonly used in pop up campers. Pop Rivets and Expansion Rivets. Pop Rivets are d...

Found on many Coleman and Fleetwood pop ups with galley lift system sinks. Installs to the bottom of the sink and connects to the drain hose. Measu...

Popular sink faucet for earlier models. Mounts off 4 inch spread stems. Sits 3-1/4 inches tall when installed. Chrome in color. Water line fittings...

Solar powered LED rope light for your camper and campsite. Auto on and off with a light sensor, and a power switch as well. Toggle switch allows On...

Fits 13" sized tires.  Strong black vinyl with corded edge and elastic closure for a snug fit. Protects tires or spares from sun and foul weather f...

Installed at the lift pillars, this trim kit keeps weather and debris out of the lift arms and act as guides for the lift arms. Finding these trims...

For Coleman and Fleetwood stepper doors. The swing arm kit holds the door in place when it is open. Single and twin packs are available. Please se...

Storage box door hinge for built boxes that have plastic sides and wood interiors. New style metal hinge. This is an upgrade to the original plasti...

Used when hanging the carryout stove or tables on the outside grill mount. The stove or table support attaches to the two brackets on the bottom of...

Lower and upper support bracket for exterior tables and stoves. This bracket can be found on an exterior body panel, top deck, frame rail or inside...

Mounts to the underside of the table, the table legs pivot on the nylon roller. This bracket will work with other designs that had different mounti...

Coleman and Fleetwood pop up tables have two of these legs. They are both the same, and work in both the left hand or right hand application. If yo...

Used to secure the table top when lowered onto the bench to form a bed. Normally, there are four found on each table. Measures 3 inches in length. ...

The shepherd's hook attaches to the bed bow and provides the center canvas support over the beds. King sized, this tent pole will fit most pop ups ...

The shepherds hook attaches to the bed bow and provides center canvas supports over the beds. The tent tip attaches to the bed bow and the double p...

Roof mounted tent pole bracket. The double push pins commonly found on the end of shepherd hook poles accept into this brace. Two are found in the ...

2 wire harness for the Atwood Hydroflame furnace thermostat. Measures 34 inches in length. Part number 4750A6431