Produkte

Low pressure hose kit for Coleman sidekick low pressure grills. Comes with everything you need to connect your Sidekick grill to the low pressure q...

The perfect accessory for a day at the beach or the pool. The towel features a decorative RV pattern design and is made of 100% cotton. It measure...

This housing covers the thrust bearing. It is used on almost every Coleman and Fleetwood pop up camper. Bolt it directly to the crossmember or fram...

Square spacer bearing retainer housing. Used in 6311 lower direct drive crank assemblies. Measures 2 inches by 2 inches squared. 9-16th of an inch ...

Used at the end of some direct drive crank assemblies.  Measures 2-1/2 inches by 2-1/2 inches. 1 inch inside diameter hole. Part number 4756-8321

This housing covers the thrust bearing. It bolts to the crossmember or frame rail with nuts, bolts and lock washers. Measures 3-1/2 inches wide by ...

Used to reinforce or space the thrust bearing. Measures 4 inches wide and 2-3/4 inches tall. 1-1/2 inch diameter hole. Color : Black Part number 47...

Grey evolution style canvas with a blue border and red accent stripe. Directly matched to the following units 1993 Sequoia series 2710 1993 Willi...

Grey Evolution canvas with a blue border. Directly matched to the following units 1992 Grandview series 2684 1992 Sequoia series 2610 1992 William...

Lower pivot bracket for the bed bow. This bracket installs at the left and right of the bed extension. It installs with two pop rivets and one wood...

A common fail point for Coleman and Fleetwood pop up camper bed bows are right in the middle. This kit is designed to fix bed bows that have suffer...

Commonly found at the bed bow mounting bracket.  This washer acts as a wear spacer between the brackets and the bow. Measures 1-1/2 inches in width...

Bed frame sections for the pull out beds. This twin kit replaces the sides of the bed frame. Directly compatible to the following unit and location...

Bed frame sections for the pull out beds. This twin kit replaces the sides of the bed frame. Directly compatible to the following unit and location...

This is the channel that bolts to the bottom of the beds, and the bed support pole slides in. This complete kit is ready to accept your bed support...

Found under the bed extension, these clips hold the bed leg poles up under the beds when stored.  Measures 1-11/16th inches across. 7/8 of an inch ...

Found under the bed extensions, these clips hold the bed leg poles up under the beds when stored.  Measures 5/8 of an inch wide by 3 inches long.  ...

Make pulling out the beds a breeze with this kit! These pull handles can install on all pop up camper bed extensions. They make controlling the bed...

This cap is found at the end of the bed rails on Fleetwood pop ups built after 1998. It is attached with a single bolt and nut to the end of the be...

Tapered machine bolt and locking nut for the bed slide wedge and bed rail end cap. Works on units produced after 1998. Part number 1201A1101

This wheel fits 1997 and prior Coleman and Fleetwood bed rails. The roller wheel sits at the front of the rail and acts as guide for the bed extens...