Produkte

Designed for metal and filon roofs. This bracket kit is for units produced through 1980 to the 2000's. Video available Found in the following AC ...

Designed for metal and filon roofs. This bracket kit is for units produced through 1980 to the 2000's. Video available Found in the following AC ...

Roof brace cover. Cover measures 79-1/4 inches long by 5 inches wide. Removed from a 1986 Plantation series Savannah.    Video available Part num...

Designed for Coleman and Fleetwood campers with metal roofs. This brace kit is required for an air conditioner installation or to fix a sagging roo...

4 caps to replace all the corners on your Coleman or Fleetwood roof. These are the original completely smooth caps. Two different versions were ava...

Found on later model units, this roof corner cap kit will fit both the front or rear of the pop up campers roof. Comes with two corner caps, and ca...

4 caps to replace all the corners on your Somerset or Fleetwood roof.  These are the later styled versions with grooves to accept the metal extrusi...

This roof cap end panel has interior brackets that are open on the bottom.  Measures 86-1/2 inches wide by 10-1/4 inches tall. This item is Shipped...

This roof cap end panel has interior brackets that are closed on the top and bottom.  Measures 86-1/2 inches wide by 10-1/4 inches tall. This item ...

Found on certain Grand Tour series roofs. This is a cap on the end of the roof at the rear of the pop up. Series 3800GT Measures 86-1/2 inches wide...

2004 Utah Grand Tour Series 3881 Measures 86-1/2 inches wide by 10-1/2 inches tall at the middle. This item is Shipped via UPS within the continent...

This is the 12 volt power harness for the interior lighting and power points if installed. It runs up one corner, commonly next to a lift pillar. M...

This is the bar that mounts to all original Coleman and Fleetwood roof mounted cross bars systems. They work with both riser tower designs for Pion...

Mounting bracket for roof mounted crossbar braces. This bracket installs on the inside of the roof. Used on roof rack systems on units produced aft...

Roof track end cap for the aluminum roofs with inset tracks. This cap terminates the front of the tracks. Measures 1-5/8 in width and 1/2 inch in h...

Roof support poles for your pop up camper are now available. Multiple uses: This product can be provide for the added piece of mind of a roof suppo...

Installs onto the roof and catches the roof latches when the camper is closed. Measures 3 inches in length, 1-3/16th inches tall and the mounting h...

Installs onto the roof and catches the roof latches when the camper is closed. Measures 3 inches in length, 1-3/16th inches tall and the mounting h...

Roof track end cap for the aluminum roofs with inset tracks. This cap terminates the rear of the tracks. Measures 1-5/8 in width and 1-1/2 inch in ...

Designed for pop up roofs, this vent will allow more ventilation by allowing rising heat to escape through the roof vent.  Video Available This v...

Thin style inner roof vent garnish. This is the trim frame that is visible from the inside of the pop up. Works with most 14 x 14 inch vents. 1-1/8...

Installation kit for roof vents. Installs 14 inch by 14 inch roof vents. Comes with putty tape and 24 screws. Part number 4609-2421

Round drive design. The output shaft on this motor has a pin through it. Only two lift motors were used and they are easily identified by the shape...

Red tail light with mounting bracket. Popular on late model units with diamond plate rear body panels. Lamp measures 4 inches across. Flange measur...