Beds

This slide wedge is found at the front, or inside of the bed rails on Fleetwood pop ups built after 1998. It is attached with a single bolt and nut...

This end cap is found at the end of the bed rails on Fleetwood pop ups built after 1998. It is attached with a single bolt and nut to the end of th...

Tapered machine bolt and locking nut for the bed slide wedge and bed rail end cap. Works on units produced after 1998. Part number 1201A1101

This kit comes with two sections of the largest shock cord, 4 hooks and 4 cord barrels. It will fit the largest and the smallest Coleman or Fleetwo...

Designed to upgrade and replace the original shock cords on Coachmen Clipper pop ups. Comes with (2) 80 inches sections of shock cord, and (4) hook...

These clinching ring clamps were primarily used on early shock cord kits. Good for creating clamps on ropes and bungees. Pack of 50 Part number 472...

Installed under the bed slides. The lashing hook holds the shock cord ends for the bed boots. These are the attachments that the shock cord hooks l...

Found under the bed extension, these clips hold the bed leg poles up under the beds when stored.  Measures 1-11/16th inches across. 7/8 of an inch ...

Found under the bed extensions, these clips hold the bed leg poles up under the beds when stored.  Measures 5/8 of an inch wide by 3 inches long.  ...

This seal installs into the small track at the ends of the beds, on both the inside and outside of the bed extensions. Video available Pop ups wi...

These are found fastened on top of the body panels, located towards the center. They assist in guiding the bed extensions up and back into the camp...

Installed on the top of the front and rear body panel rails. Acts as a rest for the bed extensions. Mounting hardware is available Measure 1-1/2" ...

Right angle bed slide stop bracket. Located at the top of the front and rear body panels on Destiny and similar model Coleman and Fleetwood pop ups...

Reinforcement bracket for bed slide stop. Measures 4 inches wide, 1 inch tall on the side with two holes, 3/8 of an inch tall on the side with 3 ho...

Bed slide stop bracket. This stop bracket is installed into the side rail. Found mostly commonly on Americana and Destiney series units. Plastic. M...

Replacement push nut for the slider function on bed support poles. Video available Easy push nut removal Fits 3/16 inch pins. Part number PAL45PF53

This push nut is found on but not limited to the following parts. Awning lead rails Pivot style bed support poles Slide style bed support poles ...

This is the channel that bolts to the bottom of the beds, and the bed support pole slides in. The slider portion of these channels can warp, making...

This is the channel that bolts to the bottom of the beds, and the bed support pole slides in. This complete kit is ready to accept your bed support...

Slider channel hardware kit for the bed support pole. This hardware kit replaces the pins and hardware on slotted slider support channels.  Videos...

Hardware kit for the installation of slide style bed support legs   This kit installs the bed support poles to the bed frame.  The order of install...

This bed support pole is commonly found on the following Coleman and Fleetwood series pop ups. Destiny Grand Tour Highlander Evolution Scorpion T...

This bed support pole is commonly found on the following Coleman and Fleetwood series pop ups. Destiny Grand Tour Highlander Evolution Scorpion T...

This style of bed support pole is commonly found on units produced up to the 2000’s. After that some smaller box sized Coleman and Fleetwood also ...