Crank Assemblies

Found in the upper lift arm stages. This clip helps secure the next stage cable to the pulley pin. It can also be used to clamp the stage and main ...

This style of pulley is found on early units. It has a needle style inner bearing and a slightly raised center mount on one side of the pulley. Com...

Lift system pulley and bearing. These pulleys are found in the bottom of the pop up, guiding the lift cables from the whiffle tree. They are also f...

Crank cover for left hand chain drive lift systems. Found on 12 foot box models built between 2000 and 2002. Series 3500 Measures 13-1/4 inches wid...

Used in the drive hub extension tubes on Coleman and Fleetwood crank assemblies. This spacer sits between the spring and flat washer, acting as a t...

Used to hold the lift pulleys in brackets inside the lift arms. This shorter pin is most commonly found at the top stage pulley. Measures 3/4 of an...

Used to hold the lift pulleys in the stage brackets on lift arms. This longer pin is most commonly found at the lower stages. The next upper stage ...

Commonly found in butterfly brackets in the bottom of lift pillars. Measures 3/4 inches in length. Part number 4720C1578

The applications for this pulley pin are at the cable routing guide just past the whiffle tree. Typically 2 pulleys are stacked one on top of each ...

Pin for lift system pulleys. Measures 1 inches in length. Part number 4731B252

This is the assembly that is pinned to the back of the power lift motor. In the instance of a failure in the power lift system, you can manually ov...

Couples the power lift motor to the whiffle tree. Measures 4 inches in length.  Part number 4773-9081

Couples the power lift motor to the whiffle tree. Measures 6 inches in length. Part number 4768-0851

Used in Cobalt and Graphite models to stabilize the crank extension. Measures 2 inches by 2 inches. 3/4 inch inside diameter hole. Part number 4768...

Used in crank assemblies, this washer has a slightly beveled edge for the shaft bushing. It's important to note the direction of this washer when r...

Guide for lift system pulleys. Series 2800 Measures 3 inches by 2-1/2 inches. Part number 4751-6031

Guide for lift system pulleys. Series 2800 Measures 3 inches by 2-1/2 inches. Could come in black or unpainted metal. Part number 4751A6021

Socket cup for the end of the whiffle tree. This socket is installed into the campers frame opposite of the crank assembly, and allows the whiffle ...

The ratchet paw is part of the mechanical brake for most lift systems. This cam engaging the ratchet wheel sprocket is what gives the Coleman and F...

This is the gear that the ratchet paw rides on, making the familiar clickety-click sound when the roof is raised. This gear has a total of 15 teeth...

This spring holds the ratchet paw cam onto the ratchet wheel gear. The ratchet paw is what gives the Coleman and Fleetwood pop ups their familiar c...

Safety latch to lock the lift system in early Coleman pop up campers. This catch is typically attached to the front or rear of the unit and catches...

This eye bolt is found on the draw bar of acme nut whiffle trees. Attaches the cables to the whiffle tree. The adjustment of this eye bolt provides...

Used on every Coleman and Fleetwood crank assembly that uses a drive hub extension tube. This collar installs in the front crank housing plate. The...