Coming Back Soon

The crank shaft bushing is found a the rear of ratchet and clutch crank assemblies. it supports the rear of the drive shaft. Inserts into a 1 inch ...

Designed for metal and filon roofs. This bracket kit is for units produced through 1980 to the 2000's. Video available Found in the following AC ...

Designed for metal and filon roofs. This bracket kit is for units produced through 1980 to the 2000's. Video available Found in the following AC ...

The tip out bow provides canvas support over the tip outs at the galley kitchen. 2 tent support tips mount the bow. Measures 51 inches wide by 44-1...

Front mounting plate for both the 3000 and 6311 direct drive crank assemblies.  Measures 7-3/4 inches wide at the base by 3 inches in height.  1-1/...

One of the earliest designs of Coleman Crank Handles. This type of crank handle was used from the start of prouction to the 1980's for most units. ...

Used in crank assemblies, this washer has a slightly beveled edge for the shaft bushing. It's important to note the direction of this washer when r...

This latch fits the grey front storage boxes on Fleetwood pop up's. This item is a product upgrade from the original. Here is an example of the sty...

The bed bow provides bunk end canvas support. This is the large U shaped pole that folds up from the beds and holds the ends. This Click Lock bed b...

Storage box door hinge for built boxes that have plastic sides and wood interiors. New style metal hinge. This is an upgrade to the original plasti...

Air conditioner power cord with 20 amp plug. Comes with enough cord to fit the largest possible pop up. Part number 4748A6591

Bed roller wheel and bracket for pre 1997 Coleman and Fleetwood pop ups. This is the roller wheels that rivet to the side of the bed. Two of these ...

The J-hook kit holds down the 20 lb LP gas bottles on the front of the pop up.  Comes with 2 J hooks, washers, and wing nuts. Measures 16-3/8 inche...

This chain drive crank system is commonly located behind a rear body panel. This is the compression system and ratchet upper crank. When you turn t...

Rigid strips, these Velcro strips have a tough backing that requires rivets or screws to install. Works with add a room and canvas to trailer body ...

Universal whiffle tree system cover. This cover bolts to the bottom of the whiffle tree system and adds stability to the lift system. This cover wi...

Fits the most common sized propane tanks: 20 pounds.  String pull on the bottom to snug the cover to the tank. This cover features a Velcro closure...

The lift lock pulls over the whiffle tree and locks the roof in place. Found most commonly on smaller box sized units, that have no crank system. C...

Found on many Coleman and Fleetwood pop ups with galley lift system sinks. Installs to the bottom of the sink and connects to the drain hose. Measu...

For Coleman and Fleetwood stepper doors. The swing arm kit holds the door in place when it is open. Single and twin packs are available. Please se...

White painted head. Torx head drive. Measures 1-1/2 inch long. 1/4" Threads. Sold individually, Please enter your required quantity to the cart. Pa...

This chain drive crank system is commonly located behind a rear body panel. This is the compression system and ratchet upper crank. When you turn t...

Side compartment door found on many Pioneer and similar series pop ups.  The cam lock is keyed to code 8025. Some scuffing is present, new old stoc...