Produits

This elbow attaches to the sink or drain connection on the side of the pop up. Comes with the drain adapter and washer. Accepts onto 1-1/2" male th...

Drain trap for the sink. This trap attaches to the bottom of the sink. A flexible corrugated drain hose is typically found attached to it which ru...

Joins thin walled drain tailpieces to 1-1/2 ABS plumbing. 1-1/2 female ABS to 1-1/2 male thin walled drain tailpieces.  Part number 4758-1391

The dual size barbed fittings make choosing the right size a snap. This valve will replace most fresh water tank drain valves. Two sized barbed fit...

The dual sized threaded fittings make choosing the right size a snap. This valve will replace most fresh water tank drain valves. Two sized threade...

Found in the drain plumbing on almost every Coleman and Fleetwood pop up built. Measures 1-7/8 inch in diameter Part number 4757-9131

Roller strike latch for cabinet doors. Keeps drawers and cabinet doors closed. 2 per pack. Part number 4733-6391

Plastic guide socket for the drawer slides. Comes as a kit with hardware. Measures 2-3/4 inches across the mounting base. Part number 4749-8361

Matching left and right metal drawer guides. These are the guides that mount to the side of cabinet drawers and allow the smooth pull / push operat...

Matching left and right used metal drawer guides. These are the guides that mount to the side of cabinet drawers and allow the smooth pull / push o...

Roller catch for cabinet doors and drawers or anywhere a friction roller is needed. Comes in a pack of two. Included are 2 rollers, 2 catches, and ...

Comes with both left hand and right hand drawer sockets. These are the plastic sockets that mount to the back of the cabinet, and hold the drawer g...

Typically found on exterior stove pull outs and inside large cabinet drawers. Mounts on 1-1/8 inch holes. Part number 4744B5851-USED

The drive hub extension threads onto the drive shaft. This crank component is what you see sticking out of the camper, and what you put the crank h...

The drive hub extension threads onto the drive shaft. This crank component is what you see sticking out of the camper, and what you put the crank h...

The drive hub extension threads onto the drive shaft. This crank component is what you see sticking out of the camper, and what you put the crank h...

The drive hub extension threads onto the drive shaft. This crank component is what you see sticking out of the camper, and what you put the crank h...

This spring is found inside the drive hub extension tube. The original springs were a simpler design, typically a coil spring. This wave spring dir...

Used in every drive hub extension tube. Commonly two are installed. These are a very thin thrust washer.  Measures 15-16th inches wide. 1/2 inch in...

The drive hub pin is most commonly found installed at the end of drive hub extension. This is the pin that the crank handle grabs onto in order to ...

Used in the drive hub extension tubes on Coleman and Fleetwood crank assemblies. This spacer sits between the spring and flat washer, acting as a t...

Drop in cooler that more than doubles the amount of food, soda and adult beverages you can bring on your next camping adventure. Directly matched t...

Fit's two 20lb LP bottles. This cover features a functional design that allows access to the gas valves on top of the bottles. The cover is designe...

Protect your propane tanks from road debris and dirt while enhancing the look of your camper. This cover will fit either (2) 20 lb. or 30 lb. stee...