Produits

Prevent hose crimping and strain, and extend hose life. 45 degree elbows eliminate unnecessary stress and strain on all RV water intake hose fittin...

Prevent hose crimping and strain which can extend hose life. 90 degree elbows eliminate unnecessary stress and strain on all RV water intake hose f...

Clear shower hose guide. The shower hose passes through this guide, and it holds the shower head in place. Part number 4769-9061

Typically found on 8 foot box units with no electric brakes. Fits 1 inch spindles. Comes complete with bearings, races, seal, super Lube dust cap, ...

Typically found on units with no electric brakes. Fits 1-1/16th inch spindles. Comes complete with bearings, races, seal, super Lube dust cap, cott...

These clips attach to the steel wheel and hold the plastic hub caps on. Found on 2000’s Bayside and Niagara models, and 2000’s Grand Tour Elite mod...

Complete hutch cabinet. Removed from a 1992 Destiny series Roanoke. Location roadside rear, to the left of the entry door. This section comes shipp...

Light beige countertop with a tan T molding. Measures 20 inches by 11-1/4 inches. Part number 4754E1631-USED

Swing bracket for the corner hutch in Plantation series units built through the 1980's. Removed from a 1986 Savannah. Measures 15 inches wide, 3 in...

Measures 2 inches wide by 2 inches tall. Part number 4616-0011

Push button faucet for the ice tub. Allows for the easy drain of melted ice. Measures 2" tall. Part number 4744-9071

Found in many Destiny and simular units, this lid sits atop the ice tub in the built in coolers. Measures 13 inches by 12-1/4 inches. Part number 4...

When replacing your air conditioner shroud, it's important to check the A/C make and model. Air conditioners were not installed at the factory. Eve...

Wedgewood low pressure indoor stove. Model D-20 Cutout measures 16 inches by 11-1/2 inches by 2-5/8 inches. Part number 4748B2581

Suburban low pressure indoor stove. Cutout measures 16 inches by 11-1/2 inches by 3-1/4 inches. Part number 2937

Atwood low pressure indoor stove box. Model D-A20R-20P Measures 16 inches by 11-3/8 inches by 3 inches. Part number 4757-0391

Interior speaker with grill, rear box and mounting screws. The rear box can be found inside the cabinet or wall behind the speaker, providing a bet...

Some regulators that Coleman and Fleetwood used had a 5/16th different input for the acme nut hose fitting. This adapter allows you to use today's ...

The J bolt kit holds down the 30 lb LP gas bottles on the front of the pop up. Comes with 2 J bolts, washers, and wing nuts. Popular on Highlander ...

Trailer tongue jack stand that eliminates the need for extra hand cranking. Supports the trailer tongue without the worry of sinking into the soft...

Tongue jack wheels make for easier maneuvering of the pop up camper. Two sizes are available. 1000 pound and 2000 pound. 1000 pound jacks work on ...

Found on front LP cover kits from the 1990's through the mid 2000's. Measures 2 inches by 2 inches. Part number 4747A9471

Comes with bracket and hardware. Measures 4-1/4 inches in length. Part number 4755-8091