Produits

This plate is found in the pulley routing block just past the whiffle tree and acts as a cover or skid plate. Part number 4720-1551

The applications for this pulley pin are at the cable routing guide just past the whiffle tree. Typically 2 pulleys are stacked one on top of each ...

Located just past the whiffle tree. This separator bracket is used to mount the 4 lift system pully's and guide the cables out from the whiffle tre...

Located just past the whiffle tree. This separator bracket is used to mount the 4 lift system pully's and guide the cables out from the whiffle tre...

For use with low boy hand pump faucets. Moving this bar over the faucet handle with allow the water to continue to run when hooked up to a city wat...

Fills screw access holes and similar. Also commonly called accordion rivets. Measures 3-8" X 3/4" Part number 4753-3341

Used to install corner caps, storage doors, hatches and more. Creates a weather tight seal behind the installed part.  Measures 3/16 Inch thick by ...

Propane Quick-Connect Kit is for use with low pressure propane systems. Quickly and easily add a convenient connect/disconnect method with an addit...

Propane Quick-Connect Kit is for use with low pressure propane systems. Quickly and easily add a convenient connect/disconnect method with an addit...

C.S.A. certified for natural gas and L.P. gas - air mixtures. Interchanges with Hansen and Sturgis brands. Quick disconnect rated to 1/2 P.S.I. Par...

Cover and hinge kit that closes off the propane quick disconnect on many models. Commonly found under the exterior stove / table support rail. Meas...

Directly matched to 1989 through 1993 Americana series Coleman pop up campers. The chain exits the right hand side of this system. This crank assem...

The ratchet pawl is part of the mechanical brake for most lift systems. This cam engaging the ratchet wheel sprocket is what gives the Coleman and ...

Measures 2 inches wide by 2 inches tall. Part number 4714-0015

This is the gear that the ratchet paw rides on, making the familiar clickety-click sound when the roof is raised. This gear has a total of 15 teeth...

Measures 79-1/4 inches wide by 22-1/4 inches tall. Please note : This item is shipped via freight systems within the United States. Please allow 2 ...

Metal diamond plate body panel. Measures 85 inches in length by 27-1/2 inches tall. This item is Shipped via freight systems within the continental...

Series 4075 Destiny. Measures 78-1/2 inches wide by 20-1/4 inches tall. Please note : This item is shipped via freight systems within the United St...

Rear body panel. Directly matched to the following unit. 2005 Niagara series 3933 Cut for five marker lights,, two taillights and rear chain driv...

Metal Panel for early 1980's Pioneer series units. Measures 78-1/4 inches wide by 22-1/4 inches tall.  Please note : This item is shipped via freig...

Removed from a 1986 Coleman Redwood. Measures 78-3/4 inches wide by 22 inches tall.  Please note : This item is shipped via freight systems within ...

Small crack in the corner, please see the final photo. Measures 79-1/4 inches wide by 22-1/4 inches tall. Please note : This item is shipped via fr...

Bulkhead for glide out. Right hand facing from the outside of the camper. It can also be called the rear. Measures 27-1/2 inches tall by 4-1/4 inch...

Bulkhead for glide outs, RH facing. RSR. Directly matched to the following units. 2003 Bayside Series 3778 2003 Utah Series 3781 2003 Niagara Seri...