Coming Back Soon

The lift arm provides lift to the pop up. They are found in each corner of the camper. CSF / Curb Side Front RSR / Road Side Rear Videos availab...

Used to trim table and countertop sides. Sold in 12 foot length. Long enough to trim the largest table with one run. Choosing the correct size. Yo...

Used in crank assemblies, this washer has a slightly beveled edge for the shaft bushing. It's important to note the direction of this washer when r...

The bed bow provides bunk end canvas support. This is the large U shaped pole that folds up from the beds and holds the canvas ends. This Click Loc...

Found on later model units, this roof corner cap kit will fit both the front or rear of the pop up campers roof. Comes with two corner caps, and ca...

The lift arm provides lift to the pop up. They are found in each corner of the camper. CSR / Curb Side Rear RSF / Road Side Front Videos availab...

Comes with strap and hardware. Strap measures 8-3/4 inches in length. Part number 4716-9691

The glide out bow provides end canvas support at the dinette. This is the large U shaped pole that folds up from the dinette and holds the canvas e...

Series 4100. 1/2 inch flared male fitting to 3/8 male. Measures 36 inches in length. Part number 4737-8871

Found on many Coleman and Fleetwood pop ups with galley lift system sinks. Installs to the bottom of the sink and connects to the drain hose. Measu...

Used on Coleman and Fleetwood pop up with an upper or left hand crank assemblies. The chain runs from the crank assembly to this gear. This gear th...

Roof support poles for your pop up camper are now available. Multiple uses: This product can be provide for the added piece of mind of a roof suppo...

Diamond plate metal wheel well.  Measurements included are of the wheel well body not the lips. Measures 23 inches wide, 12 inches deep, and 6 inch...

The bed bow provides bunk end canvas support. This is the large U shaped pole that folds up from the beds and holds the ends. This Click Lock bed b...

Series 3300. 1/2 MNPT male fitting to 3/8 inch male flare. Measures 36 inches in length. Part number 4733A3991

Used to provide center canvas support. C clasp attaches to the bed bow, and the duck bill / ball cap attaches to the roof bracket. Designed for dou...

Designed for metal and filon roofs. This bracket kit is for units produced through 1980 to the 2000's. Video available Found in the following AC ...

The whiffle tree is the threaded rod mounted in the bottom of the pop up. A draw bar runs up and down the rod and pulls or releases the cables. Thi...

Exterior metal roof cap. This cap hides the installation of the exterior roof brace for the hat bracket. Found on ABS roofs that had the curved AC ...

The shepherd's hook attaches to the bed bow and provides the center canvas support over the beds. King sized, this tent pole will fit most pop ups ...

The tent pole attaches to the glide out bow and provides center canvas supports over the glide out. Tent support tip attaches to the bow and the du...

Found on Clipper pop ups, this plunger acts as the lock for the bed rails. Four are found on each unit. Pulling the knob up allows the bed system t...

The bed bow provides bunk end canvas support. This is the large U shaped pole that folds up from the beds and holds the canvas ends. Designed for T...

This LP hose runs from the propane tank to the low pressure regulator. Acme nut to 1/4 inch inverted MPT. Hose measures 15 inches in length. The in...