Coming Back Soon

The screen door track installs at the ceiling and the sliders hang the screen door when not in use. The final image shows an example of the screen ...

This bed support pole is commonly found on the following Coleman and Fleetwood series pop ups. Destiny Grand Tour Highlander Evolution Scorpion T...

The lift arm provides lift to the pop up. They are found in each corner of the camper. CSF / Curb Side Front RSR / Road Side Rear Videos availab...

The crank shaft bushing is found a the rear of ratchet and clutch crank assemblies. it supports the rear of the drive shaft. Inserts into a 1 inch ...

The shepherd's hook attaches to the bed bow and provides the center canvas support over the beds. King sized, this tent pole will fit most pop ups ...

Designed for metal and filon roofs. This bracket kit is for units produced through 1980 to the 2000's. Video available Found in the following AC ...

Designed for metal and filon roofs. This bracket kit is for units produced through 1980 to the 2000's. Video available Found in the following AC ...

Butterfly switch safety key. Locks the lift system in Plantation series models. This key raises and lowers the locking paw. Video available Key c...

Butterfly switch safety key. Locks the lift system in many 1980 and early 1990 models. This key raises and lowers the locking paw. Video available...

This bracket is found on ABS roofs that have had a curved roof brace installed. Installed on top of the roof, this bracket holds the carriage bolts...

Comes with a green vinyl patch, and 1 FL. OZ. of high strength VLP. Measures 18 inches by 18 inches. Part number VPKG

The tip out bow provides canvas support over the tip outs at the galley kitchen. 2 tent support tips mount the bow. Measures 51 inches wide by 44-1...

Front mounting plate for both the 3000 and 6311 direct drive crank assemblies.  Measures 7-3/4 inches wide at the base by 3 inches in height.  1-1/...

This light is commonly found in mid-1990s to mid-2000s Coleman and Fleetwood  pop ups. It attaches to a tent pole with 2 gripper clips located on t...

One of the earliest designs of Coleman Crank Handles. This type of crank handle was used from the start of prouction to the 1980's for most units. ...

This component is what the remote plugs into. Only two different style current limiters were used and the plugs easily differentiate them. Power be...

Used in crank assemblies, this washer has a slightly beveled edge for the shaft bushing. It's important to note the direction of this washer when r...

This is the channel that bolts to the bottom of the beds, and the bed support pole slides in. This complete kit is ready to accept your bed support...

Designed for most Coleman Fleetwood campers with ABS tops. This brace kit has a curved design to fit the plastic roofs that have experienced saggin...

Designed for pop up roofs, this vent will allow more ventilation by allowing rising heat to escape through the roof vent.  Video Available This v...

Fits almost every air conditioner installed on Coleman and Fleetwood pop up campers. Direct fit: Coleman Mach 1, 2, and 3. The most common Coleman ...

Used to raise and lower the roof on Coleman's and Fleetwood's equipped with power lift systems. This remote plugs into the current limiter which is...

Fits 17 inch jacks and 20 inch jacks. Sand shoes help stabilize the camper. A wider footprint on the ground equals more comfort with less rocking i...

Installation kit for roof vents. Installs 14 inch by 14 inch roof vents. Comes with putty tape and 24 screws. Part number 4609-2421