Coleman Pop Up Parts

Used on coleman and Fleetwood pop up with an upper or left hand crank assemblies. The chain runs from the crank assembly to this gear. This gear th...

Water line with 1/2 inch female fittings. Measures 60 inches in length. Part number 4769-129

Air conditioner roof brace mounting bracket. Series 3800, 4396, 4391 and 4389 Measures 3 inches in overall length by 1-1/2 inches wide. Part numbe...

Designed for most Coleman Fleetwood campers with ABS tops. This brace kit has a curved design to fit the plastic roofs that have experienced saggin...

Air conditioner power cord with 20 amp plug. Comes with enough cord to fit the largest possible pop up. Part number 4748A6591

Specifically designed for pop ups. Comes with a low pressure auto changeover and two 15 inch acme nuts. The kit does not come pre assembled, consid...

Auxiliary power port for 1/4 input 12 volt equipment such as reading lamps and fans. This port is commonly installed on the ceiling, close to the t...

Looking for quick relief from the hot afternoon sun? The A&E Systems Trim Line patio awning installs easily on your camper's awning rail, provi...

Used to secure the awning from the camper to the awning lead rail. Found on almost every original Coleman and Fleetwood bag awning. Original Colema...

The whiffle tree is the threaded rod mounted in the bottom of the pop up. A draw bar runs up and down the rod, and pulls or releases the cables. Th...

A common fail point for Coleman and Fleetwood pop up camper bed bows are right in the middle. This kit is designed to fix bed bows that have suffer...

This wheel fits 1997 and prior Coleman and Fleetwood bed rails. The roller wheel sits at the front of the rail and acts as guide for the bed extens...

Bed roller wheel and bracket for pre 1997 Coleman and Fleetwood pop ups. This is the roller wheels that rivet to the side of the bed. Two of these ...

This style of bed support pole is commonly found on units produced up to the 2000’s. After that some smaller box sized Coleman and Fleetwood also u...

This style of bed support pole is commonly found on units produced up to the 2000’s. After that some smaller box sized Coleman and Fleetwood also u...

This bed support pole is commonly found on units produced after the 2000's. This is the pole that stabilizes the bed. Two are found under each bed ...

This bed support pole is commonly found on the following Coleman and Fleetwood series pop ups. Highlander Evolution This is the pole that stabili...

Comes with screws and face plate. LED light monitors system status. With Reset Button And LED Light Indication Of No Power Mis-wire Or End Of Life...

Exterior or interior cable TV plate. Painted surface inhibits rust, fade or discolor. Comes with rubber dust cover. Installation screws are availab...

Stove support bracket for exterior stoves, grills, and tables. This is the rail that attaches to the side of your Coleman or Fleetwood pop up. Mea...

12 volt ceiling lamp with a white plastic lens. Add a pack of light bulbs to your order here Measures 6-1/2 inches long by 4-1/2 inches wide. Part ...

Dome light lens. Measures 4-7/8 inches squared. Directly matched to the this ceiling lamp, lamp part number 4737E5911. Part number 4714D0891

Ceiling light lens. Series 4200. Measures 3-3/4 inches wide by 4-1/4 inches tall.  Part number 4758-1361