Was a tad bit smaller than the original, had to drill new holes, but that was fine, I just resealed the old hole with some flexible caulk and it looks great! No more broken power cord hatch for us!
Had to notch out the old hole a little with some tin snips. A hack saw would have worked as well. Used some butyl tape from the hardware store for a proper seal. Good as new! Thanks!
I used this part to replace the original on my 1998 Coleman Santa Fe. It only took me about 15 minutes to remove the old part and install the new. Looks and works great.
Replacement part on old camper- hard part is taking the old one off - but this one tucks into the coleman fleetwood popup camper exactly and has three Phillips head screws ( included) to easily install
Quick and easy install - I took my time and it was about 10 minutes. Holes lines up perfectly on my Taos, although I did re-use my old screws for no particular reason. Was a bit sloppy with the putty, but my old one had basically no weatherproofing so I was glad to see this included.
This is the 3" bucket, the ring is slightly smaller then the original so I had plug the old holes and make new ones when installing. Sadly I need to order another one because the plastic pin on the door cracked when I was pulling my electric line out.
Store owner replied:
Sorry that happened Matthew. Please give me a call. Derek.
As always, good service, quick shipping and the part fit perfectly. Easy to install--couple of screws and an easy-to-put-on waterproofing seal. Easy, peasy.
Easy to install. The holes didn’t line up but the screws were self tapping so was super easy to attach. Just need to put some silicone caulk and all done!!!
I used this site several times to find replacement parts for my Coleman Tent Trailer and have been happy with each purchase. My trailer is a 2003 but I've been able to keep it looking like it's new!
The part is about 3/4" in diameter smaller than the original, so the screw holes don't line up. The plastic is very thin compared to the original. I unfortunately had to put the OEM part back on.
