Résultats pour la recherche « keys »

This black stove grate is found on most Coleman and Fleetwood 2 and 3 burner stoves. Mounting feet measure 8 inches apart.  Part number 4752A9881

Plastic replacement thumb lock used in various hatches. The hole for this lock can be no larger than 7/8" I.D. and at least 3/4" I.D. Press in lo...

This spring is found inside the drive hub extension tube. The original springs were a simpler design, typically a coil spring. This wave spring dir...

This roof latch catch is commonly found on earlier units. Installs on the roof, the pop up roof latches grab this bracket to secure the roof closed...

Stainless steel TEK screws to install trims, latches, hatches and more. Common uses for these fasteners on pop up campers are... Cable hatches Wat...

These are the original larger sized snap washers found in Coleman and Fleetwood pop ups. These are found under the original snap caps. Plastic scre...

These bed rails works with almost every Coleman and Fleetwood pop up built prior to June 1997. Ready to install and set for most king sized beds an...

These swing down corner jacks come equipped on most small box sized Coleman and Fleetwood pop ups. Video available Rated to 1000 Lb. Adjust from ...

These bulbs will replace most of the interior lamps in units from the 1990's to the 2000's. This bulb pushes in a flat socket. Cool and warm option...

A popular replacement for both inside and outside showers. Comes complete with 60 inch vinyl hose, shower head with on/off switch. Mounting and hos...

Accepts a 30 amp power cord. This power cord hatch has a slightly larger outside mounting flange. It will cover a bit more surface area from your o...

Found on Clipper pop ups, this plunger acts as the lock for the bed rails. Four are found on each unit. Pulling the knob up allows the bed system t...

The drive hub extension threads onto the drive shaft. This crank component is what you see sticking out of the camper, and what you put the crank h...

Hard plastic slide rails for Coleman and Fleetwood pop ups. These slides work with the bed extensions that do not have rollers. These slide rails a...

This style of pulley is commonly found on early units. It has a needle style inner bearing and a slightly raised center mount on one side of the pu...

This lens is solid red. No bottom tag illumination. Dimensions are 8 1/2 inches wide by 4 1/2 inches tall. The complete assembly is found here Part...

This latch is found on units where the access door lock sits to the side of the door, mounted in a body panel. Always found on access doors that sw...

Accepts a 1-3/8" water fill hose. Comes complete with a vent. Direct replacement for Coleman and Fleetwood pop up fresh water fill hatches for olde...

Barrel adjuster and cam. Measures 1-5/8 inches in length. Part number 4714A2041

The duck bill attaches to the ceiling end of the shepherds hook, or tent support pole. Sometimes the tip out or glide out pole uses this cap at the...

A slightly larger Coleman and Fleetwood stabilizer jack. This jack is designed for units that may have over-sized tires or an axle flip that has gi...

Attaches the shepherd hook tent support pole to the bed bow. This clasp latches over the center of the bow on beds, glide outs and tip outs. The en...

This chain drive crank system is commonly located behind a rear body panel. This is the compression system and ratchet upper crank. When you turn t...