Products

Adds a cutting surface and extend your counter space. Gain more convenience and versatility with this easy upgrade. Fits the larger porcelain sinks...

Found on many Coleman and Fleetwood pop ups with galley lift system sinks. Installs to the bottom of the sink and connects to the drain hose. Measu...

Hardware kit for the installation of slide style bed support legs   This kit installs the bed support poles to the bed frame.  The order of install...

Solar powered LED rope light for your camper and campsite. Auto on and off with a light sensor, and a power switch as well. Toggle switch allows On...

Found in the upper lift arm stages. This clip helps secure the next stage cable to the pulley pin. It can also be used to clamp the stage and main ...

For Coleman and Fleetwood stepper doors. The swing arm kit holds the door in place when it is open. Single and twin packs are available. Please sel...

This latch fits the grey front storage boxes on Fleetwood pop up's. This item is a product upgrade from the original. Here is an example of the sty...

Metal stabilizer handle for the swing down jacks. This jack tool fits into the circle slots, and ratcheting up and down lowers the jacks securely t...

Lower and upper support bracket for exterior tables and stoves. This bracket can be found on an exterior body panel, top deck, frame rail or inside...

Lower support bracket for the exterior tables and stoves. This bracket can be found on an exterior body panel, frame rail or inside a swing style d...

Mounts to the underside of the table, the table legs pivot on the nylon roller. This bracket will work with other designs that had different mounti...

Used for table leg storage. This kit is attached to the bottom of the dinette tables and secures the legs when collapsed. Measures 9 inches un-stre...

Coleman and Fleetwood pop up tables have two of these legs. They are both the same, and work in both the left hand or right hand application. If yo...

The shepherds hook attaches to the bed bow and provides center canvas supports over the beds. The tent tip attaches to the bed bow and the double p...

This mounting base is located behind the furnace thermostat. Tan in color. Measures 6-5/8 inches outside square and 5 inches inside square. Part nu...

2 wire harness for the Atwood Hydroflame furnace thermostat. Measures 34 inches in length. Part number 4750A6431

Installs on the whiffle tree and holds the 3000 series thrust bearing. Most commonly used on units with chain driven lift systems. Dimensions are 2...

The tip out bow provides canvas support over the tip outs at the galley kitchen. 2 tent support tips mount the bow. Measures 51 inches wide by 44-1...

This bolt kit installs at the rear of many Coleman and Fleetwood pop ups. They extrude from the rear body panel and are installed into a spare tire...

This bracket is found on ABS roofs that have had a curved roof brace installed. Installed on top of the roof, this bracket holds the carriage bolts...

The tent pole attaches to the glide out bow or tip out bow, and provides center canvas supports over the glide out or tip out. Comes with all possi...

The shepherd's hook attaches to the bed bow and provides the center canvas support over the beds. King sized, this tent pole will fit most pop ups ...

Everything you need to install a USB self powered water faucet directly to your fresh water tank. This solution is perfect for smaller units that o...

The drive hub extension threads onto the drive shaft. This is the crank component that you see sticking out of the camper and what you put the cran...