Crank Assemblies

This cover bolts to the bottom of the whiffle tree system and adds stability to the lift system. Measures 32-1/4 inches long by 11-1/4 inches wide....

Universal whiffle tree system cover. This cover bolts to the bottom of the whiffle tree system and adds stability to the lift system. This cover wi...

Located just past the whiffle tree. This separator bracket is used to mount the 4 lift system pully's and guide the cables out from the whiffle tre...

Located just past the whiffle tree. This separator bracket is used to mount the 4 lift system pully's and guide the cables out from the whiffle tre...

This plate is found in the pulley routing block just past the whiffle tree.  Measures 4-1/4 inches long by 1-3/8 inches tall. Part number 4720F154

The application for this pulley retainer is at the cable routing just past the whiffle tree. Typically 2 pulleys are stacked one on top of each oth...

This housing covers the thrust bearing. It is used on almost every Coleman and Fleetwood pop up camper. Bolt it directly to the crossmember or fram...

Square spacer bearing retainer housing. Used in 6311 lower direct drive crank assemblies. Measures 2 inches by 2 inches squared. 9-16th of an inch ...

Used at the end of some direct drive crank assemblies.  Measures 2-1/2 inches by 2-1/2 inches. 1 inch inside diameter hole. Part number 4756-8321

Commonly found on Pioneer series similar units. This carrier bearing centers the extension rod attached to the whiffle tree. Mounting holes are spa...

Butterfly switch safety key. Locks the lift system in many 1980 and early 1990 models. This key raises and lowers the locking paw. Video available...

Butterfly switch safety key. Locks the lift system in Plantation series models. This key raises and lowers the locking paw. Video available Key c...

Located in the bottom of the lift arm pillars. The main lift cable routes through this bracket and pulley. Videos available Comes complete with ...

This is the crimp that secures lift cable ends. Both loop style lift cables and bolt style lift cables use this crimp to make the loop. The lift ar...

The coupler connects the whiffle tree or extension rod to the crank assembly. Found on 6311 direct drive systems, and units that use extension rods...

Stage cable kit with two pre looped ends. These cables are located in the 4 stage lift arms. See the video "Lift Arm Remove / Rebuild" to learn how...

Stage cable with two pre looped ends. This cable is located in the 3 stage lift arms. See the video "Lift Arm Remove / Rebuild" to learn how to pro...

This cable comes one end crimped and the other open to make a custom lift pillar cable. 1 Cable crimp for the open end is included. Measures 48 inc...

Found in the upper lift arm stages. This clip helps secure the next stage cable to the pulley pin. It can also be used to clamp the stage and main ...

This style of pulley is found on early units. It has a needle style inner bearing and a slightly raised center mount on one side of the pulley. Com...

Lift system pulley and bearing. These pulleys are found in the bottom of the pop up, guiding the lift cables from the whiffle tree. They are also f...

Crank cover for left hand chain drive lift systems. Found on 12 foot box models built between 2000 and 2002. Series 3500 Measures 13-1/4 inches wid...

Used in the drive hub extension tubes on Coleman and Fleetwood crank assemblies. This spacer sits between the spring and flat washer, acting as a t...

Used to hold the lift pulleys in brackets inside the lift arms. This shorter pin is most commonly found at the top stage pulley. Measures 3/4 of an...