Cerca risultati per 'tent support bracket'

Designed for Coleman and Fleetwood campers with ABS tops. This brace kit has a curved design to fit the plastic roofs that have experienced sagging...

Used in most pop up campers, this is the seal that secures the canvas to the camper roof. It is found at the top of the canvas, and sets into the p...

Angle brackets that position the battery box to the front frame of the camper. Comes with 2 brackets and installation rivets. Brackets measure 1-1/...

Bracket for the installation of vanity mate and camper caddie systems. Measures 2-1/4 inches tall with a 2 inch wide base. Part number 4768-1161

Lower support bracket for the exterior tables and stoves. This bracket can be found on an exterior body panel, frame rail or inside a swing style d...

This is the channel that bolts to the bottom of the beds, and the bed support pole slides in. This complete kit is ready to accept your bed support...

Assortment of the most p[popular brackets to build and mount the cabinets in your pop up camper. Comes with the following. 4 Large Brackets 2 Floo...

The duck bill attaches to the ceiling end of the shepherds hook, or tent support pole. Sometimes the tip out or glide out pole uses this cap at the...

Bracket for the pivot style bed support poles. This bracket installs under the bed frame, and pins the bed support pole that pivots down. Measures ...

Jack mounting bracket for Highlander series pop ups. Series 3600C Measures 8-1/8 inches wide by 5-1/8 inches long by 2-1/2 inches tall. Part number...

Lower pivot bracket for the bed bow. This bracket installs at the left and right of the bed extension. Video available Measures 2-1/2 inches lon...

Located in the bottom of the lift arm pillars. The main lift cable routes through this bracket and pulley. Videos available Comes complete with ...

The shepherd's hook attaches to the bed bow and provides the center canvas support over the beds. Double bed sized, this tent pole style is a direc...

Extra long table or stove rail mount kit. Comes with both the rail to mount to the camper, and the matching side to mount to the table, stove or gr...

This tent pole attaches to the tip out bow and provides center canvas supports over the tip out. Tent support tip attaches to the bow and the duck ...

Lower bracket for the swing down galley system. This bracket holds the lower 12 tooth gear. Position: Left Hand Facing Measures 4" X 1-7/8" Part nu...

Found at the front corner of the glide out, or nearest the tongue.  Measures 24-5/8 inches long, by 1-1/2 X 1-5/8 inches. Part number 4756B3361

This new style roof support post locks the roof into the up position on Rockwood, Flagstaff, Clipper and many other Forest River campers. A New Upg...

Corner gusset for the curb side front and road side rear location on certain Coleman and Fleetwood pop up campers without a front storage box. This...

Lower pivot bracket for the bed bow. This bracket installs at the left and right of the bed extension. Series 3600. Video available Measures 2 in...

Designed for Coleman and  Fleetwood campers with metal or filon tops. This brace could be required for an air conditioner installation or a sagging...

Located inside the glide out box, this bracket mounts the grab handle. Two are found inside each glide out box. Measures 7-1/8 inches long, 1-1/2 i...

Mounting bracket for roof mounted crossbar braces. This bracket installs on the inside of the roof. Used on roof rack systems on units produced aft...

Found on grey storage boxes on Fleetwood and Somerset campers. Located under the paddle latch, this bracket acts as the lid stop. Measures 3 inches...