Cerca risultati per 'tent support bracket'

The tip out bow provides canvas support over the tip outs at the galley kitchen. Two tent support tips mount the bow into two plastic cups in the c...

Lower bracket for the swing down galley system. This bracket holds the lower 12 tooth gear. Position: Right Hand Facing Measures 4" X 1-7/8" Part n...

The end rail cap is the metal bracket that mounts on top of the front and rear body panels. This cap is installed most commonly with stainless stee...

Designed for Coleman and  Fleetwood campers with metal or filon tops. This brace could be required for an air conditioner installation or a sagging...

Used to mount low pressure regulators that have a rear vent. This system will mount the regulator vertically. Slides over the vertical rod between ...

Single pin tent pole spring. Used In Coleman and Fleetwood canvas support poles. This pin is the action spring to allows you to adjust the length o...

Reinforcement bracket for bed slide stop. Measures 4 inches wide, 1 inch tall on the side with two holes, 3/8 of an inch tall on the side with 3 ho...

Lower pivot pole for 3 piece bed bows. Colonial white in color. Measures 28-5/8 inches in length. Part number 4737D2641

The tip out bow provides canvas support over the tip outs at the galley kitchen. 2 tent support tips mount the bow. Measures 46 inches wide by 47 -...

Peel and stick mesh patches. * Repair holes in tent mesh and mosquito nets.* Fine mesh keeps out no-see-ums.* Includes 4 patches. Each patch measur...

Lower and upper support bracket for exterior tables and stoves. This bracket can be found on an exterior body panel, top deck, frame rail or inside...

Pole bracket for the sun shade awning systems. This system is designed for roof’s that have two awning rails, one on each side. Over the glide out ...

Lower pivot bracket for the bed bow. This bracket installs at the left and right of the bed extension. It installs with two pop rivets and one wood...

On the top corners of the deck rails you can find these corner brackets. They cover the four corners of the top rails. Series 3300. Measures 1-7/8 ...

Corner gusset for the road side front and curb side rear location on certain Coleman and Fleetwood pop ups without front storage boxes. This inner ...

The screen door storage bracket is used to secure the screen door in stored position for closing. Located directly above the door opening, riveted ...

These brackets fit the the left hand and right hand ends of the 4800-4811 roof brace. They secure to the roof curtain and canvas tracks and hold th...

This table leg bracket has been built to last. Made completely out of metal, this version has no plastic cup that is prone to break.   Video avail...

An easy upgrade kit for adding two propane tanks. This kit mounts to the trailer tongue, and holds two 20 pound LP tanks. Comes with base, threaded...

Designed for Coleman and Fleetwood campers with metal or filon tops. This brace could be required for an air conditioner installation or a sagging ...

Base plate mounting kit to add a second LP tank. Installs on top of the pop up A frame. Measures 37-1/4 inches across the top, 28-1/2 inches across...

This bracket Installs at the end of ABS roof braces. Works with this style of roof brace. Measures 3-1/2 inches in width by 2 inches tall. 1-5/8 o...

Found on front LP cover kits from the 1990's through the mid 2000's. Measures 2 inches by 2 inches. Part number 4747A9471

The J-hook kit holds down the 20lb LP gas bottles on the front of the pop up. 20LB tanks are the most common size on pop up campers. Comes with 2 J...