Products

Ceiling light lens. Series 4200. Measures 3-3/4 inches wide by 4-1/4 inches tall.  Part number 4758-1361

Used in upper crank assemblies. The crank assembly gears and mechanism ride on this drive shaft. The drive hub extension tube threads onto the seco...

This 5/8 nut threads onto the end of coarse thread drive shafts. This is the final nut found on the end of drive shafts for crank assemblies. Early...

The Coleman Mach 3 is one of the best RV air conditioning values available. It features a large evaporator and condenser coils with raised lance fi...

This is the original Coleman Fleetwood amber marker lamp lens. It features a slightly different radius on each corner that was a design Coleman and...

This is the original Coleman Fleetwood amber marker lamp lens. It features a slightly different radius on each corner that was a design Coleman and...

Side compartment door found on many Pioneer and similar series pop ups.  The cam lock is keyed to code 8025. Some scuffing is present, new old stoc...

This chain drive crank system is commonly located behind a rear body panel. This is the compression system and ratchet upper crank. When you turn t...

This chain drive crank system is commonly located behind a rear body panel. This is the compression system and ratchet upper crank. When you turn t...

The crank shaft bushing is found a the rear of ratchet and clutch crank assemblies. it supports the rear of the drive shaft. Inserts into a 1 inch ...

Plastic sink strainer crumb basket. Measures 1 inch tall. Part number 4714C0661

This plastic roof track is found in many Coleman and Fleetwood pop ups.  Found inside the roof, it hangs the curtains and canvas. The top track is ...

This is one of the most common curtain C clips found in Coleman and Fleetwood pop ups. It slides or snaps over the 5/8" curtain track found in many...

Installed at the lift pillars, this trim kit keeps weather and debris out of the lift arms and act as guides for the lift arms. Finding these trims...

This popular crank system for Coleman and Fleetwood pop ups is for units with lower direct drive lifts. This crank is found in the rear bumper, dir...

Front mounting plate for both the 3000 and 6311 direct drive crank assemblies.  Measures 7-3/4 inches wide at the base by 3 inches in height.  1-1/...

Located at the entryway to your pop up. This is attached to the floor, and commonly called the "screen door support" in your parts book. Measures 2...

Matching left and right used metal drawer guides. These are the guides that mount to the side of cabinet drawers and allow the smooth pull / push o...

Popular on 1990's and early 2000's models. 12 volt interior ceiling lamp. Squared design with on/off switch and power port for auxiliary equipment ...

Holds the tent support poles with duck bill caps to the ceiling. Referred to the steel loop in the parts books, this can also be found for table br...

One of the earliest designs of Coleman Crank Handles. This type of crank handle was used from the start of prouction to the 1980's for most units. ...

Used in upper crank assemblies, and the lower left hand chain drive system found on certain 12 foot box units. The crank assembly gears and mechani...

Used for folding wall systems in pop ups with indoor showers. Removed from a 1986 Plantation series Savannah. Please choose your length from the dr...

Commonly found next to galley lift systems. This block acts as a rest when the galley sink system is lowered. Some glide outs use this as a guide b...